From: Rafael J. Wysocki <rafael.j.wysocki@xxxxxxxxx> If dev is NULL in __gpiod_get_index() and both ACPI and OF are enabled, it will be checked twice before the code decides to give up with DT/ACPI lookup, so avoid that. Also use the observation that ACPI_COMPANION() is much more efficient than ACPI_HANDLE(), because the latter uses the former and carries out a check and a pointer dereference on top of it, so replace the ACPI_HANDLE() check with an ACPI_COMPANION() one which does not require the additional IS_ENABLED(CONFIG_ACPI) check too. Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@xxxxxxxxx> --- drivers/gpio/gpiolib.c | 16 +++++++++------- 1 file changed, 9 insertions(+), 7 deletions(-) Index: linux-pm/drivers/gpio/gpiolib.c =================================================================== --- linux-pm.orig/drivers/gpio/gpiolib.c +++ linux-pm/drivers/gpio/gpiolib.c @@ -1865,13 +1865,15 @@ struct gpio_desc *__must_check __gpiod_g dev_dbg(dev, "GPIO lookup for consumer %s\n", con_id); - /* Using device tree? */ - if (IS_ENABLED(CONFIG_OF) && dev && dev->of_node) { - dev_dbg(dev, "using device tree for GPIO lookup\n"); - desc = of_find_gpio(dev, con_id, idx, &lookupflags); - } else if (IS_ENABLED(CONFIG_ACPI) && dev && ACPI_HANDLE(dev)) { - dev_dbg(dev, "using ACPI for GPIO lookup\n"); - desc = acpi_find_gpio(dev, con_id, idx, &lookupflags); + if (dev) { + /* Using device tree? */ + if (IS_ENABLED(CONFIG_OF) && dev->of_node) { + dev_dbg(dev, "using device tree for GPIO lookup\n"); + desc = of_find_gpio(dev, con_id, idx, &lookupflags); + } else if (ACPI_COMPANION(dev)) { + dev_dbg(dev, "using ACPI for GPIO lookup\n"); + desc = acpi_find_gpio(dev, con_id, idx, &lookupflags); + } } /* -- To unsubscribe from this list: send the line "unsubscribe linux-gpio" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html