Re: [RFC Patch] gpio: add GPIO hogging mechanism

[Benoit Parrot <bparrot@xxxxxx>]

Maxime Ripard <maxime.ripard@xxxxxxxxxxxxxxxxxx> wrote on Wed [2014-Oct-29 17:47:46 +0100]:
> On Wed, Oct 29, 2014 at 11:41:22AM -0500, Benoit Parrot wrote:
> > Maxime Ripard <maxime.ripard@xxxxxxxxxxxxxxxxxx> wrote on Wed [2014-Oct-29 11:45:59 +0100]:
> > > Hi,
> > > 
> > > On Tue, Oct 21, 2014 at 03:09:58PM -0500, Benoit Parrot wrote:
> > > > Based on Boris Brezillion work this is a reworked patch
> > > > of his initial GPIO hogging mechanism.
> > > > This patch provides a way to initally configure specific GPIO
> > > > when the gpio controller is probe.
> > > > 
> > > > The actual DT scanning to collect the GPIO specific data is performed
> > > > as part of the gpiochip_add().
> > > > 
> > > > The purpose of this is to allows specific GPIOs to be configured
> > > > without any driver specific code.
> > > > This particularly usueful because board design are getting
> > > > increassingly complex and given SoC pins can now have upward
> > > > of 10 mux values a lot of connections are now dependent on
> > > > external IO muxes to switch various modes and combination.
> > > > 
> > > > Specific drivers should not necessarily need to be aware of
> > > > what accounts to a specific board implementation. This board level
> > > > "description" should be best kept as part of the dts file.
> > > > 
> > > > Signed-off-by: Benoit Parrot <bparrot@xxxxxx>
> > > 
> > > I've been thinking about this for quite some time, it's good to see
> > > some progress on that :)
> > > 
> > > However, I have a slightly different use case for it: the Allwinner
> > > SoCs have a vdd pin coming in for every gpio bank. Nothing out of the
> > > ordinary so far, except that some of the boards are using a
> > > GPIO-controlled regulator to feed another bank vdd. That obviously
> > > causes a chicken-egg issue, since for the gpio-regulator driver to
> > > probe, it needs to gpio driver, and for the gpio driver to probe, it
> > > needs the regulator driver.
> > 
> > Unless the gpio controlling the vdd pin is from the same bank your
> > trying to power up I do not see the issue here.
> 
> Not the same bank, but the same driver.

How are you currently working around this issue?

> 
> -- 
> Maxime Ripard, Free Electrons
> Embedded Linux, Kernel and Android engineering
> http://free-electrons.com


--
To unsubscribe from this list: send the line "unsubscribe linux-gpio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html