On 04/04/2013 05:39 AM, Stephen Warren wrote:
> A simple frame-buffer describes a raw memory region that may be rendered
> to, with the assumption that the display hardware has already been set
> up to scan out from that buffer.
>
> This is useful in cases where a bootloader exists and has set up the
> display hardware, but a Linux driver doesn't yet exist for the display
> hardware.
>
> Signed-off-by: Stephen Warren <swarren@xxxxxxxxxxxxx>
> ---
> v2: s/dumb/simple/ throughout. Provide more details on pixel format.
>
> I ended up going with a separate FB driver:
> * DRM/KMS look much more complex, and don't provide any benefit that I can
> tell for this simple driver.
> * Creating a separate driver rather than adjusting offb.c to work allows a
> new clean binding to be defined, and doesn't require removing or ifdefing
> PPC-isms in offb.c.
> ---
> .../bindings/video/simple-framebuffer.txt | 25 +++
> drivers/video/Kconfig | 17 ++
> drivers/video/Makefile | 1 +
> drivers/video/simplefb.c | 234 ++++++++++++++++++++
> 4 files changed, 277 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/video/simple-framebuffer.txt
> create mode 100644 drivers/video/simplefb.c
>
> diff --git a/Documentation/devicetree/bindings/video/simple-framebuffer.txt b/Documentation/devicetree/bindings/video/simple-framebuffer.txt
> new file mode 100644
> index 0000000..3ea4605
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/video/simple-framebuffer.txt
> @@ -0,0 +1,25 @@
> +Simple Framebuffer
> +
> +A simple frame-buffer describes a raw memory region that may be rendered to,
> +with the assumption that the display hardware has already been set up to scan
> +out from that buffer.
> +
> +Required properties:
> +- compatible: "simple-framebuffer"
> +- reg: Should contain the location and size of the framebuffer memory.
> +- width: The width of the framebuffer in pixels.
> +- height: The height of the framebuffer in pixels.
> +- stride: The number of bytes in each line of the framebuffer.
> +- format: The format of the framebuffer surface. Valid values are:
> + - r5g6b5 (16-bit pixels, d[15:11]=r, d[10:5]=g, d[4:0]=b).
> +
> +Example:
> +
> + framebuffer {
> + compatible = "simple-framebuffer";
> + reg = <0x1d385000 (1600 * 1200 * 2)>;
> + width = <1600>;
> + height = <1200>;
> + stride = <(1600 * 2)>;
> + format = "r5g6b5";
> + };
I'm not an expert on DT, but I think the point of DT is to describe the
hardware. This doesn't describe the hardware at all.
Tomi
Attachment:
signature.asc
Description: OpenPGP digital signature
