Le 02/08/2012 02:34, Shawn Guo a écrit :
> On Wed, Aug 01, 2012 at 12:28:27PM +0200, Maxime Ripard wrote:
>> Thanks for the tip.
>> However, I'm not sure this device will be mxs specific, since this
>> controller is used on some other devices as well (I know for example
>> that some uses it with the Arduino, even though it's not related to
>> Linux), so relying on mxs-specific capabilities here might not be that
>> great.
>>
> Ok, agreed. In that case, putting "1" in last cell of oled-reset-gpio
> does not make any point then.
>
> +Examples:
> +ssd1307: oled@3c {
> + compatible = "solomon,ssd1307fb-i2c";
> + reg = <0x3c>;
> + pwms = <&pwm 4 3000>;
> + oled-reset-gpio = <&gpio2 7 1>;
> + oled-reset-active-low;
> +};
>
Ok, I will do that then.
Maxime
--
Maxime Ripard, Free Electrons
Kernel, drivers, real-time and embedded Linux
development, consulting, training and support.
http://free-electrons.com
--
To unsubscribe from this list: send the line "unsubscribe linux-fbdev" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
