Le 10/03/2011 21:20, Leonardo Borda a écrit : > Hello Guys, Hi Leonardo, > I am trying to configure bridge + bonding with arp monitoring enabled. > Whenever I activate the bridge interface and assign bond0 to the bridge > Everything stops working. > > I am on ubuntu 10.04 LTS. > > Can I have an ip address in the bond0 interface WHILE not having an IP > address in the bridge interface? > In order to have bond arp monitoring I must have an ip address in the > bond interface as far as I understand. Did you try to setup the IP address on br0 instead? I think it should work. Do you have any reasons to put the IP address on bond0 instead? > Here it is my current configuration. > PS: I have seen similar configurations although none of them have an ip > address configured in the bond0 interface. > > # The loopback network interface > auto lo > iface lo inet loopback > > auto bond0 > iface bond0 inet static > address 10.153.107.110 > netmask 255.255.255.0 > gateway 10.153.107.1 > bond-slaves none > bond-mode active-backup > bond_arp_ip_target 10.153.107.1 > bond_arp_interval 500 > > auto eth0 > iface eth0 inet manual > bond-master bond0 > bond-primary eth0 eth1 > > auto eth1 > iface eth1 inet manual > bond-master bond0 > bond-primary eth0 eth1 > > auto br0 > iface br0 inet manual > bridge_ports bond0 > bridge_stp off > bridge_fd 9 > bridge_hello 2 > bridge_maxage 12 > bridge_maxwait 0 > > Leonardo > > > ------------------------------------------------------------------------------ > Colocation vs. Managed Hosting > A question and answer guide to determining the best fit > for your organization - today and in the future. > http://p.sf.net/sfu/internap-sfd2d > _______________________________________________ > Bonding-devel mailing list > Bonding-devel@xxxxxxxxxxxxxxxxxxxxx > https://lists.sourceforge.net/lists/listinfo/bonding-devel > _______________________________________________ Bridge mailing list Bridge@xxxxxxxxxxxxxxxxxxxxxxxxxx https://lists.linux-foundation.org/mailman/listinfo/bridge
