Hello,
I'm trying to get bridging to work between eth0 and usb0:
192.168.13.2 <---> br0:192.168.13.47 <---> 192.168.13.1
usb0 eth0
192.168.13.2:~ # ping 192.168.13.1
... 100 % packet loss
On 192.168.13.1 I do see the arp requests but no icmp packet :-/
Just like "No traffic gets trough (except ARP and STP)" in the
FAQ on http://www.linux-foundation.org/en/Net:Bridge
Except ...
I can ping 192.168.13.1 from the bridge (192.168.13.47)
Trying to ping 192.168.13.2 from the bridge does not work
I do see the arp requests for 192.168.13.2 on 192.168.13.1 (!)
I get the same result if if enable STP on the bridge.
What is going wrong here? :-/
Any hint appreciated!
Regards,
andreas
PS: The bridge system is a SUSE 10.2 with kernel 2.6.18.8-0.7-default
(incl. suse patches) usb0 is a MosChip usb nic using the mcs7830 driver
and eth0 is an on board intel nic. both work fine in non bridging mode.
my routing table (just ignore the vmnet stuff):
bibo:/proc/sys/net/ipv4 # route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
10.0.0.0 0.0.0.0 255.255.255.0 U 0 0 0 vmnet8
192.168.13.0 0.0.0.0 255.255.255.0 U 0 0 0 br0
10.0.10.0 0.0.0.0 255.255.255.0 U 0 0 0 vmnet1
127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo
0.0.0.0 192.168.13.1 0.0.0.0 UG 0 0 0 br0
Filtering is not enabled as far as I can see:
bibo:/proc/sys/net/bridge # ls
bridge-nf-call-arptables bridge-nf-call-iptables
bridge-nf-call-ip6tables bridge-nf-filter-vlan-tagged
bibo:/proc/sys/net/bridge # cat *
0
0
0
0
bibo:/proc/sys/net/bridge #
# iptables -vnL
Chain INPUT (policy ACCEPT 842 packets, 683K bytes)
pkts bytes target prot opt in out source destination
Chain FORWARD (policy ACCEPT 0 packets, 0 bytes)
pkts bytes target prot opt in out source destination
Chain OUTPUT (policy ACCEPT 885 packets, 98734 bytes)
pkts bytes target prot opt in out source destination
How I set up the bridge:
# ifconfig usb0 0.0.0.0 down
# ifconfig eth0 0.0.0.0 down
# brctl addbr br0
# brctl addif br0 eth0
# brctl addif br0 usb0
# ifconfig br0 192.168.13.47 up
# brctl show br0
bridge name bridge id STP enabled interfaces
br0 8000.000d6080dcd6 no eth0
usb0
_______________________________________________
Bridge mailing list
Bridge@xxxxxxxxxxxxxxxxxxxxxxxxxx
https://lists.linux-foundation.org/mailman/listinfo/bridge