BRUNETON Béranger wrote:>> I have been struggling for ages with this device, trying get the firmware to load.>>>> The program I wrote to extract the firmware from the driver now outputs the Intel Hex format too, used by fxload.>> No luck : the A3 part does not get loaded, not even using fxloads' A3-loader>>>> Details and downloads of code, logs etc at http://www.bsc-bvba.be/linux/dvb>>>> I could use some help, like :>>>> traces of the firmware being loaded on XP/Vista (I am using USBspy myself), preferably using a hardware protocol analyser>>>> recommendations for an affordable hardware USB2 protocol analyser (I'd try to compare the XP-log with the non-working Linux log)>>>> suggestions on how to proceed ...> > > Do you know why it doesn't support S2 channels ?> Hardware or software limitation ?> > > Regards> I don't have much in the way of DVB-expertise, but here goes :1) WinTV-CI doesn't participate in getting the signal, so changes in tuners/modulation standards/... etc shouldn't bother it2) It is a USB2-device so should have the raw bandwidth to handle a HDTV stream3) It uses the smartcard you'd use normally, so the actual decryption is done with the same hardware so I'd venture it's a software limitation. Luc _______________________________________________linux-dvb users mailing listFor V4L/DVB development, please use instead linux-media@xxxxxxxxxxxxxxxxxxxxxxxx@linuxtv.orghttp://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
