On Mon, Apr 13, 2009 at 11:29 PM, John Orth <john@xxxxxxxxxxxxxx> wrote: > First, thanks to all for the wonderful v4l project. I am able to get > this card going in Ubuntu 9.04 on my laptop (Dell Vostro 1700) with no > changes apart from copying the correct firmware. What fantastic > progress. :) > > I have been trying very hard to get this USB tuner to work on my Asus > M3A78-EM board in Ubuntu 9.04 with no success. I have tried the stock > Jaunty kernel, the mainline (vanilla?) kernel, the included kernel > modules, and modules compiled from v4l Mercurial with no success. > Generally speaking, after a cold boot, the stick will work for a while. > It will scan channels, lock one or two, and then I will receive a filter > timeout. Once the filter has timed out, not even a cold boot will > revive the stick. I have to power down the system, remove the stick, > and place it in a different USB port. Once I have done this, I am able > to filter/lock with varying degrees of success. Sometimes it will allow > me to generate a full channels.conf, sometimes not. However, once > hitting the "filter timeout" error, dmesg gets flooded with: > > --- > s5h1411_writereg: writereg error 0x19 0xf5 0x0000, ret == 0) > dib0700: i2c write error (status = -108) > --- > > The filter timeout occurs after running "scan tuning.dat > channels.conf" > The file tuning.dat is generated via "w_scan -fa -x > tuning.dat" > > The firmware dvb-fe-xc5000-1.1.fw was copied to /lib/firmware per the > v4l Wiki instructions. > > lspci of working system: http://pastebin.com/f31efd30a > lspci of non-working system: http://pastebin.com/fa80c2f7 > > Is there something major I'm overlooking? Are there any known issues > with this hardware combination? I am willing to test any changes to the > xc5000 driver if needed. > > Thanks! > John Hello John, I added support for that device. A couple of questions: 1. Are you sure the port on the PC supports USB 2.0? 2. Which application are you using to test with? 3. Are you doing anything with suspend/resume on the PC? 4. Are you plugged directly into the USB port, or are you using any sort of USB extension cable? Once I know the answers to the above questions, I will see what I can figure out. Regards, Devin -- Devin J. Heitmueller http://www.devinheitmueller.com AIM: devinheitmueller _______________________________________________ linux-dvb users mailing list For V4L/DVB development, please use instead linux-media@xxxxxxxxxxxxxxx linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
