|
I just bought two Hauppauge HVR-1600 cards
and I'm trying to set them up in Mythdorra 5. I have the cx18 drivers
installed but it is only initializing one card. I'm getting the following message when
I do a dmesg | grep cx18. Has anyone ran accross this problem before with
duel cards of the same model and if so, how do I fix it? Any help will be greatly
appreciated. Thanks, Tom Moore Houston, TX dmesg | grep cx18 cx18: Start initialization, version
1.0.1 cx18-0: Initializing card #0 cx18-0: Autodetected Hauppauge card cx18-0: Unreasonably low latency timer,
setting to 64 (was 32) cx18-0: cx23418 revision 01010000 (B) cx18-0: Autodetected Hauppauge HVR-1600 cx18-0: VBI is not yet supported tuner 2-0061: chip found @ 0xc2 (cx18 i2c
driver #0-1) cs5345 1-004c: chip found @ 0x98 (cx18 i2c
driver #0-0) cx18-0: Disabled encoder IDX device cx18-0: Registered device video0 for encoder
MPEG (2 MB) DVB: registering new adapter (cx18) cx18-0: DVB Frontend registered cx18-0: Registered device video32 for encoder
YUV (2 MB) cx18-0: Registered device video24 for encoder
PCM audio (1 MB) cx18-0: Initialized card #0: Hauppauge
HVR-1600 cx18-1: Initializing card #1 cx18-1: Autodetected Hauppauge card cx18-1: Unreasonably low latency timer,
setting to 64 (was 32) cx18-1: ioremap failed, perhaps increasing
__VMALLOC_RESERVE in page.h cx18-1: or disabling CONFIG_HIGHMEM4G into
the kernel would help cx18-1: Error -12 on initialization cx18: probe of 0000:02:04.0 failed with error
-12 cx18: End initialization |
_______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
