Honestly spoken I never tried the 1.20 firmware on the NOVA-T 500. (This card was last used in DiBcom 3 years ago.) It might be that using the new i2c-requests along with the I2C-master do not work with some boards. In that case you can still use the new i2c-requests but you need to select the gpio-bus instead of the i2c-master-bus. Patrick. On Thu, 28 Aug 2008, Devin Heitmueller wrote: > On Thu, Aug 28, 2008 at 8:05 PM, Thomas Goerke <tom@xxxxxxxxxxxx> wrote: >> I did a little more debugging and it seems that the I still have a problem >> with the .20 version. However, you only see it after a cold reset ie when >> you need to load the firmware. See below for the first dmesg which is with >> the .20 firmware. As you can see the card is found but only in a cold >> state. The second dmesg is with the .10 firmware and the card is found >> firstly in a cold state and then in a warm state. Each of these dmesg >> outputs have been after a power off from the power supply for 10 seconds ie >> no power to backplane. > > Wow, that's so early in the loading process for the device, it's hard > to see how that can have anything to do with my i2c changes. > > Patrick, do you have any changelogs that describe the differences > between 1.10 and 1.20 other than the addition of the new i2c API? > > Devin > > -- > Devin J. Heitmueller > http://www.devinheitmueller.com > AIM: devinheitmueller > _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
