Chaogui Zhang wrote: > On Wed, Aug 13, 2008 at 5:33 AM, Paul Marks <paul@xxxxxxxxxx> wrote: >> On Tue, Aug 12, 2008 at 12:58 AM, Paul Marks <paul@xxxxxxxxxx> wrote: >>> I have a DViCO FusionHDTV5 RT Gold, with an IR sensor that connects to >>> the back of the card. The remote is a "Fusion Remote MCE". The video >>> capture stuff works just fine, but I've had no such luck with the >>> remote. >> Just to confirm some things: >> - The remote control works using DViCO's software on Windows Vista x64. >> - The remote is not detected in Ubuntu 8.04.1 >> >> I normally run Gentoo with kernel 2.6.26, but I tested with an Ubuntu >> Live CD, to be sure I wasn't forgetting some trivial kernel module. >> > > Do the following and see if it works: > > Power off your system (don't just reboot), then unplug power, wait for > 20 seconds and plug it back in then start your Ubuntu. > > If this works, that means the IR receiver got messed up somehow and > only a complete power cut can reset it. I have seen this happening > tons of times when I tried to get the IR on my HDTV5 RT Gold to work > last summer. > If this is true, and the IR device reset line is wired to the bridge, we should try to identify the GPIO and force a device reset on driver load. ... assuming it's actually wired and reset capable. - Steve _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
