Hi Mark, Forgive my ignorance/ newbie-ness, but what do I do with that patch code below? is there a tutorial or howto or something somewhere that will introduce me to this. I have done some programming, but nothing of this level. cheers Jon ----- Original Message ----- From: "Jonathan Hummel" <jhhummel@xxxxxxxxxxx> To: "Mark Carbonaro" <mark@xxxxxxxxxxxxx> Cc: stev391@xxxxxxxxx, linux-dvb@xxxxxxxxxxx Sent: Tuesday, 5 August, 2008 10:21:11 PM (GMT+1000) Auto-Detected Subject: Re: [PATCH-TESTERS-REQUIRED] Leadtek Winfast PxDVR 3200 H - DVB Only support Hi Jon, Not a problem at all, I'm new to this myself, below is what went through and I may not be doing it the right way either. So if anyone would like to point out what I am doing wrong I would really appreciate it. The file that I downloaded was called v4l-dvb-2bade2ed7ac8.tar.bz2 which I downloaded from http://linuxtv.org/hg/~stoth/v4l-dvb/archive/tip.tar.bz2, I also saved the patch to the same location as the download. The patch didn't apply for me, so I manually patched applied the patches and created a new diff that should hopefully work for you also (attached and inline below). From what I could see the offsets in Stephens patch were a little off for this code snapshot but otherwise it is all good. I ran the following using the attached diff... tar -xjf v4l-dvb-2bade2ed7ac8.tar.bz2 cd v4l-dvb-2bade2ed7ac8 patch -p1 < ../Leadtek.Winfast.PxDVR.3200.H.2.diff Once the patch was applied I was then able to build and install the modules as per the instructions in the INSTALL file. I ran the following... make all sudo make install >From there I could load the modules and start testing. I hope this helps you get started. Regards, Mark diff -Naur v4l-dvb-2bade2ed7ac8/linux/Documentation/video4linux/CARDLIST.cx23885 v4l-dvb2/linux/Documentation/video4linux/CARDLIST.cx23885 --- v4l-dvb-2bade2ed7ac8/linux/Documentation/video4linux/CARDLIST.cx23885 2008-08-05 11:18:19.000000000 +1000 +++ v4l-dvb2/linux/Documentation/video4linux/CARDLIST.cx23885 2008-08-05 23:27:32.000000000 +1000 @@ -10,3 +10,4 @@ 9 -> Hauppauge WinTV-HVR1400 [0070:8010] 10 -> DViCO FusionHDTV7 Dual Express [18ac:d618] 11 -> DViCO FusionHDTV DVB-T Dual Express [18ac:db78] + 12 -> Leadtek Winfast PxDVR3200 H [107d:6681] diff -Naur v4l-dvb-2bade2ed7ac8/linux/drivers/media/video/cx23885/Kconfig v4l-dvb2/linux/drivers/media/video/cx23885/Kconfig --- v4l-dvb-2bade2ed7ac8/linux/drivers/media/video/cx23885/Kconfig 2008-08-05 11:18:19.000000000 +1000 +++ v4l-dvb2/linux/drivers/media/video/cx23885/Kconfig 2008-08-05 23:37:51.000000000 +1000 @@ -15,6 +15,7 @@ select DVB_S5H1409 if !DVB_FE_CUSTOMISE select DVB_S5H1411 if !DVB_FE_CUSTOMISE select DVB_LGDT330X if !DVB_FE_CUSTOMISE + select DVB_ZL10353 if !DVB_FE_CUSTOMISE select MEDIA_TUNER_XC2028 if !DVB_FE_CUSTOMIZE select MEDIA_TUNER_TDA8290 if !DVB_FE_CUSTOMIZE select MEDIA_TUNER_TDA18271 if !DVB_FE_CUSTOMIZE diff -Naur v4l-dvb-2bade2ed7ac8/linux/drivers/media/video/cx23885/cx23885-cards.c v4l-dvb2/linux/drivers/media/video/cx23885/cx23885-cards.c --- v4l-dvb-2bade2ed7ac8/linux/drivers/media/video/cx23885/cx23885-cards.c 2008-08-05 11:18:19.000000000 +1000 +++ v4l-dvb2/linux/drivers/media/video/cx23885/cx23885-cards.c 2008-08-05 23:41:40.000000000 +1000 @@ -155,6 +155,10 @@ .portb = CX23885_MPEG_DVB, .portc = CX23885_MPEG_DVB, }, + [CX23885_BOARD_LEADTEK_WINFAST_PXDVR3200_H] = { + .name = "Leadtek Winfast PxDVR3200 H", + .portc = CX23885_MPEG_DVB, + }, }; const unsigned int cx23885_bcount = ARRAY_SIZE(cx23885_boards); @@ -230,6 +234,10 @@ .subvendor = 0x18ac, .subdevice = 0xdb78, .card = CX23885_BOARD_DVICO_FUSIONHDTV_DVB_T_DUAL_EXP, + },{ + .subvendor = 0x107d, + .subdevice = 0x6681, + .card = CX23885_BOARD_LEADTEK_WINFAST_PXDVR3200_H, }, }; const unsigned int cx23885_idcount = ARRAY_SIZE(cx23885_subids); @@ -353,6 +361,10 @@ if (command == 0) bitmask = 0x04; break; + case CX23885_BOARD_LEADTEK_WINFAST_PXDVR3200_H: + /* Tuner Reset Command */ + bitmask = 0x00070404; + break; case CX23885_BOARD_DVICO_FUSIONHDTV_7_DUAL_EXP: case CX23885_BOARD_DVICO_FUSIONHDTV_DVB_T_DUAL_EXP: if (command == 0) { @@ -492,6 +504,15 @@ mdelay(20); cx_set(GP0_IO, 0x000f000f); break; + case CX23885_BOARD_LEADTEK_WINFAST_PXDVR3200_H: + /* GPIO-2 xc3028 tuner reset */ + /* Put the parts into reset and back */ + cx_set(GP0_IO, 0x00040000); + mdelay(20); + cx_clear(GP0_IO, 0x00000004); + mdelay(20); + cx_set(GP0_IO, 0x00040004); + break; } } @@ -579,6 +600,7 @@ case CX23885_BOARD_HAUPPAUGE_HVR1200: case CX23885_BOARD_HAUPPAUGE_HVR1700: case CX23885_BOARD_HAUPPAUGE_HVR1400: + case CX23885_BOARD_LEADTEK_WINFAST_PXDVR3200_H: default: ts2->gen_ctrl_val = 0xc; /* Serial bus + punctured clock */ ts2->ts_clk_en_val = 0x1; /* Enable TS_CLK */ @@ -592,6 +614,7 @@ case CX23885_BOARD_HAUPPAUGE_HVR1800: case CX23885_BOARD_HAUPPAUGE_HVR1800lp: case CX23885_BOARD_HAUPPAUGE_HVR1700: + case CX23885_BOARD_LEADTEK_WINFAST_PXDVR3200_H: request_module("cx25840"); break; } diff -Naur v4l-dvb-2bade2ed7ac8/linux/drivers/media/video/cx23885/cx23885-dvb.c v4l-dvb2/linux/drivers/media/video/cx23885/cx23885-dvb.c --- v4l-dvb-2bade2ed7ac8/linux/drivers/media/video/cx23885/cx23885-dvb.c 2008-08-05 11:18:19.000000000 +1000 +++ v4l-dvb2/linux/drivers/media/video/cx23885/cx23885-dvb.c 2008-08-05 23:37:03.000000000 +1000 @@ -37,6 +37,7 @@ #include "tda8290.h" #include "tda18271.h" #include "lgdt330x.h" +#include "zl10353.h" #include "xc5000.h" #include "tda10048.h" #include "tuner-xc2028.h" @@ -502,6 +503,32 @@ } break; } + case CX23885_BOARD_LEADTEK_WINFAST_PXDVR3200_H: + i2c_bus = &dev->i2c_bus[0]; + + port->dvb.frontend = dvb_attach(zl10353_attach, + &dvico_fusionhdtv_xc3028, + &i2c_bus->i2c_adap); + if (port->dvb.frontend != NULL) { + struct dvb_frontend *fe; + struct xc2028_config cfg = { + .i2c_adap = &dev->i2c_bus[1].i2c_adap, + .i2c_addr = 0x61, + .video_dev = port, + .callback = cx23885_tuner_callback, + }; + static struct xc2028_ctrl ctl = { + .fname = "xc3028-v27.fw", + .max_len = 64, + .demod = XC3028_FE_ZARLINK456, + }; + + fe = dvb_attach(xc2028_attach, port->dvb.frontend, + &cfg); + if (fe != NULL && fe->ops.tuner_ops.set_config != NULL) + fe->ops.tuner_ops.set_config(fe, &ctl); + } + break; default: printk("%s: The frontend of your DVB/ATSC card isn't supported yet\n", dev->name); diff -Naur v4l-dvb-2bade2ed7ac8/linux/drivers/media/video/cx23885/cx23885.h v4l-dvb2/linux/drivers/media/video/cx23885/cx23885.h --- v4l-dvb-2bade2ed7ac8/linux/drivers/media/video/cx23885/cx23885.h 2008-08-05 11:18:19.000000000 +1000 +++ v4l-dvb2/linux/drivers/media/video/cx23885/cx23885.h 2008-08-05 23:37:33.000000000 +1000 @@ -66,6 +66,7 @@ #define CX23885_BOARD_HAUPPAUGE_HVR1400 9 #define CX23885_BOARD_DVICO_FUSIONHDTV_7_DUAL_EXP 10 #define CX23885_BOARD_DVICO_FUSIONHDTV_DVB_T_DUAL_EXP 11 +#define CX23885_BOARD_LEADTEK_WINFAST_PXDVR3200_H 12 /* Currently unsupported by the driver: PAL/H, NTSC/Kr, SECAM B/G/H/LC */ #define CX23885_NORMS (\
Attachment:
Leadtek.Winfast.PxDVR.3200.H.2.diff
Description: Binary data
_______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
