|
Hi I sent in this a few days ago, but no one has been able to help yet. Please can someone help me. Thanks Ben Hi I am a complete newbie looking for help getting the Remote for an Avermedia Super 007 (Digital only) working. After looking around I believe that adding support should only require adding a new case to the (dev->board) switch in the saa7134-input.c file titled: SAA7134_BOARD_AVERMEDIA_SUPER_007 Questions: 1. Is this forum the right place to be asking these questions? If not, where is please? 2. Should adding the relevant information to the saa7134-input.c file for an otherwise supported saa7134 dvb-t card result in the remote being supported? 3. If so, how do I determine what information needs to be supplied. ie: - are the ir_codes_avermedia appropriate for this card - how do you tell what the mask_keycode and mask_keydown should be? - how do you work out the appropriate polling interval - what part does saa_setb play in all this. I have the card working and am able to upload any supported information needed. Thanks in advance for your help - BVJ. My New Box: 2.6.24-19-generic x86_64 GNU/Linux (Mythbuntu 8.04 fully patched) AMD Athalon X2 64 B4850 Gigabyte MA78GM-S2H with AMD 780 Northbridge & ATI HD 3200 Graphics Avermedia Super 007 (Digital Only) saa7133 & tda8290 LSPCI output: 03:06.0 Multimedia controller: Philips Semiconductors SAA7133/SAA7135 Video Broadcast Decoder (rev d1) Subsystem: Avermedia Technologies Inc Unknown device f01d Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 32 (21000ns min, 8000ns max) Interrupt: pin A routed to IRQ 20 Region 0: Memory at fdcff000 (32-bit, non-prefetchable) [size=2K] Capabilities: [40] Power Management version 2 Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 PME-Enable- DSel=0 DScale=1 PME- 00: 31 11 33 71 06 00 90 02 d1 00 80 04 00 20 00 00 10: 00 f0 cf fd 00 00 00 00 00 00 00 00 00 00 00 00 20: 00 00 00 00 00 00 00 00 00 00 00 00 61 14 1d f0 30: 00 00 00 00 40 00 00 00 00 00 00 00 0b 01 54 20 40: 01 00 02 06 00 20 00 1c 00 00 00 00 00 00 00 00 50: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 60: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 70: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 80: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 90: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 a0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 b0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 c0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 d0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 e0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 f0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 DMESG output: [ 47.222507] Linux video capture interface: v2.00 [ 47.407888] saa7130/34: v4l2 driver version 0.2.14 loaded [ 47.407972] saa7133[0]: found at 0000:03:06.0, rev: 209, irq: 20, latency: 32, mmio: 0xfdcff000 [ 47.407979] saa7133[0]: subsystem: 1461:f01d, board: Avermedia Super 007 [card=117,autodetected] [ 47.407988] saa7133[0]: board init: gpio is 40000 [ 47.542574] saa7133[0]: i2c eeprom 00: 61 14 1d f0 54 20 1c 00 43 43 a9 1c 55 d2 b2 92 [ 47.542581] saa7133[0]: i2c eeprom 10: ff ff ff ff ff 20 ff ff ff ff ff ff ff ff ff ff [ 47.542586] saa7133[0]: i2c eeprom 20: 01 40 01 32 32 01 01 43 88 ff 00 55 ff ff ff ff [ 47.542590] saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 47.542595] saa7133[0]: i2c eeprom 40: ff 21 00 c0 96 10 03 02 15 16 ff ff ff ff ff ff [ 47.542599] saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 47.542603] saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 47.542607] saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 47.932906] tuner 1-004b: chip found @ 0x96 (saa7133[0]) [ 47.981769] tda8290 1-004b: setting tuner address to 60 [ 48.084618] tuner 1-004b: type set to tda8290+75a [ 48.132535] tda8290 1-004b: setting tuner address to 60 [ 48.236347] tuner 1-004b: type set to tda8290+75a [ 48.239259] saa7133[0]: registered device video0 [v4l2] [ 48.239278] saa7133[0]: registered device vbi0 [ 48.330034] saa7134 ALSA driver for DMA sound loaded [ 48.330064] saa7133[0]/alsa: saa7133[0] at 0xfdcff000 irq 20 registered as card -2 [ 48.356488] DVB: registering new adapter (saa7133[0]) [ 48.356494] DVB: registering frontend 0 (Philips TDA10046H DVB-T)... [ 48.428950] tda1004x: setting up plls for 48MHz sampling clock [ 48.712424] tda1004x: found firmware revision 20 -- ok Bees, cows, tigers and more! Windows Live Messenger treats you to 30 free emoticons. Sell your car for just $40 at CarPoint.com.au It's simple! |
_______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
