I've been trying to amend the M920x driver to cope with the MT2060 tuner. My dmesg output looks encouraging :
usb 5-1: new high speed USB device using ehci_hcd and address 5
usb 5-1: configuration #1 chosen from 1 choice
Probing for m920x device at interface 0
dvb-usb: found a 'Dposh(mt2060 tuner) DVB-T USB2.0' in warm state.
dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.
DVB: registering new adapter (Dposh(mt2060 tuner) DVB-T USB2.0)
m920x_mt352_frontend_attach
DVB: registering frontend 0 (Zarlink MT352 DVB-T)...
m920x_mt2060_tuner_attach
MT2060: successfully identified (IF1 = 1220)
dvb-usb: Dposh(mt2060 tuner) DVB-T USB2.0 successfully initialized and connected.
but scanning produces no result. I thought it might be the firmware so I used USBSnoop ( ver 2.0 from here , I think its slightly easier to use than the original) and extracted a new firmware file (attached) . The firmware loaded without complaint, but still no scan result. I'm a bit stuck now, anyone got any suggestions as to how I should proceed?
regards Andrew
_______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
