On 5/2/08, luc legrand <legrandluc@xxxxxxxxx> wrote: > Hi ! > > I have an Avermedia M115 MiniPCI hybrid that worked very well (I only > use DVB-T with kaffeine) using v4l-dvb-experimentral of Markus > Rechberger until kernel 2.6.24. > Some info about this TV tuner here : > http://www.avermedia.com/cgi-bin/products_odm_M115.asp > http://bttv-gallery.de/ > > Since kernel 2.6.24 I don't find how to make it work so I decide to > give a try to the v4l-dvb tree on linuxtv.org. > I followed the installation instructions here (case 2) : > http://www.linuxtv.org/wiki/index.php/How_to_install_DVB_device_drivers > The compilation seems to go without errors > > Then I followed the instructions here for the firmware (section how to > obtain the firmware) : > http://www.linuxtv.org/wiki/index.php/Xceive_XC3018 > > But kaffeine doesn't recognize the tv tuner. > > Here is dmesg | grep saa : > > saa7130/34: v4l2 driver version 0.2.14 loaded > saa7133[0]: found at 0000:09:04.0, rev: 209, irq: 16, latency: 0, > mmio: 0xd2005000 > saa7133[0]: subsystem: 1461:a836, board: Avermedia M115 > [card=138,autodetected] > saa7133[0]: board init: gpio is a400000 > saa7133[0]: i2c eeprom 00: 61 14 36 a8 00 00 00 00 00 00 00 00 00 00 00 00 > saa7133[0]: i2c eeprom 10: ff ff ff ff ff 20 ff ff ff ff ff ff ff ff ff ff > saa7133[0]: i2c eeprom 20: 01 40 01 02 02 01 01 03 08 ff 00 c0 ff ff ff ff > saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > saa7133[0]: i2c eeprom 40: ff 65 00 ff c2 1e ff ff ff ff ff ff ff ff ff ff > saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > saa7133[0]: i2c eeprom 80: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > saa7133[0]: i2c eeprom 90: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > saa7133[0]: i2c eeprom a0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > saa7133[0]: i2c eeprom b0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > saa7133[0]: i2c eeprom c0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > saa7133[0]: i2c eeprom d0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > saa7133[0]: i2c eeprom e0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > saa7133[0]: i2c eeprom f0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > tuner' 1-0061: chip found @ 0xc2 (saa7133[0]) > saa7133[0]: registered device video0 [v4l2] > saa7133[0]: registered device vbi0 > > here is dmesg | grep DVB : > > DVB: Unable to find symbol xc2028_attach() > > here is lspci -v : > > 09:04.0 Multimedia controller: Philips Semiconductors SAA7133/SAA7135 > Video Broadcast Decoder (rev d1) > Subsystem: Avermedia Technologies Inc Device a836 > Flags: bus master, medium devsel, latency 64, IRQ 16 > Memory at d2005000 (32-bit, non-prefetchable) [size=2K] > Capabilities: [40] Power Management version 2 > Kernel driver in use: saa7134 > Kernel modules: saa7134 > > I try to use it under kdetv or tvtime without success and here is what > dmesg tells me : > > tuner' 1-0061: Tuner has no way to set tv freq > > Here is what I see when I look in > linux/drivers/media/video/saa7134/saa7134-cards.c of v4l-dvb at > linuxtv.org : > > 4206 [SAA7134_BOARD_AVERMEDIA_M115] = { > 4207 .name = "Avermedia M115", > 4208 .audio_clock = 0x187de7, > 4209 .tuner_type = TUNER_XC2028, > 4210 .radio_type = UNSET, > 4211 .tuner_addr = ADDR_UNSET, > 4212 .radio_addr = ADDR_UNSET, > 4213 .inputs = {{ > 4214 .name = name_tv, > 4215 .vmux = 1, > 4216 .amux = TV, > 4217 .tv = 1, > 4218 }, { > 4219 .name = name_comp1, > 4220 .vmux = 3, > 4221 .amux = LINE1, > 4222 }, { > 4223 .name = name_svideo, > 4224 .vmux = 8, > 4225 .amux = LINE2, > 4226 } }, > 4227 }, > > And here is what I see when I look in > linux/drivers/media/video/saa7134/saa7134-cards.c of > v4l-dvb-experimental at mcentral.de > > 1709 [SAA7134_BOARD_AVERMEDIA_M115] = { > 1710 .name = "Avermedia M115", > 1711 .audio_clock = 0x187de7, > 1712 .tuner_type = TUNER_XCEIVE_XC3028, > 1713 .radio_type = UNSET, > 1714 .tuner_addr = 0x61, > 1715 .radio_addr = ADDR_UNSET, > 1716 .mpeg = SAA7134_MPEG_DVB, > 1717 .inputs = {{ > 1718 .name = name_tv, > 1719 .vmux = 1, > 1720 .amux = TV, > 1721 .tv = 1, > 1722 },{ > 1723 .name = name_comp1, > 1724 .vmux = 3, > 1725 .amux = LINE1, > 1726 },{ > 1727 .name = name_svideo, > 1728 .vmux = 8, > 1729 .amux = LINE2, > 1730 }}, > 1731 }, > > Are the differences ok ? I mean especially for the tuner type. > Do I made an error during the instalation ? > If no, what can I do in order to help you add the support for this card ? > I updated the build script of v4l-dvb-experimental with the patch that was submitted to the ML. Markus _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
