Hello, I have a Hauppauge HVR-1700 PCI Express, I have read all posts about this card here, but I didn't get it working, how does it work? Kernel: linux-2.6.25-git10 Firmware-Files: ls -al /lib/firmware/2.6.25-git10/ total 416 drwxr-xr-x 2 root root 91 Apr 27 16:27 . drwxr-xr-x 3 root root 25 Apr 27 16:26 .. -rw-r--r-- 1 root root 24878 Apr 27 16:27 dvb-fe-tda10048-1.0.fw -r--r--r-- 1 root root 16382 Apr 27 16:27 v4l-cx23885-avcore-01.fw -r--r--r-- 1 root root 376836 Apr 27 16:26 v4l-cx23885-enc.fw The modules I use are from the actual v4l-dvb hg, if I type make load, the only thing I get is a /dev/video0, but I have no picture with xawtv... The DVB doesn't work at all, I have no /dev/dvb*, here is my dmesg: cx23885 driver version 0.0.1 loaded ACPI: PCI Interrupt 0000:02:00.0[A] -> GSI 24 (level, low) -> IRQ 24 CORE cx23885[0]: subsystem: 0070:8101, board: Hauppauge WinTV-HVR1700 [card=8,autodetected] cx23885[0]: i2c bus 0 registered cx23885[0]: i2c bus 1 registered cx23885[0]: i2c bus 2 registered tveeprom 0-0050: Huh, no eeprom present (err=-5)? tveeprom 0-0050: Encountered bad packet header [00]. Corrupt or not a Hauppauge eeprom. cx23885[0]: warning: unknown hauppauge model #0 cx23885[0]: hauppauge eeprom: model=0 cx23885[0]: cx23885 based dvb card tda10048_readreg: readreg error (ret == -5) cx23885[0]: frontend initialization failed cx23885_dvb_register() dvb_register failed err = -1 cx23885_dev_setup() Failed to register dvb on VID_C cx23885_dev_checkrevision() New hardware revision found 0x0 cx23885_dev_checkrevision() Hardware revision unknown 0x0 cx23885[0]/0: found at 0000:02:00.0, rev: 2, irq: 24, latency: 0, mmio: 0xfe800000 Thank you and greetings Torben Viets _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
