hermann pitton wrote: > Hi, Trevor and Amitay, > > Am Dienstag, den 22.04.2008, 07:38 +1000 schrieb Trevor Boon: >> Hi Amitay, >> >> I specified the i2c_scan=1 option in my >> /etc/modprobe.d/saa7134 file and the following >> addresses were returned.. >> >> saa7130[0]: i2c scan: found device @ 0xa0 [eeprom] >> saa7130[0]: i2c scan: found device @ 0xc0 [tuner >> (analog)] >> >> Regards, >> Trevor. >> > > the 0x10 >> 1 for the digital demod is in the eeprom, if it follows > usual rules, at least the tuner is correct there. > > Likely there are more possibilities, why the tda10048 does not appear, > powered off for example to safe energy, but since you also had a crash > previously, try a cold boot at first, means wait some time without any > power connected, depending on capacitors of the mobo, but 30 seconds > without any power should be always safe, and then just let it auto > detect card=0 without a tuner again and let i2c_scan=1 enabled one more > time. > > If still the same, you are likely above that basic testing step and can > scratch heads on what doing next. If this doesn't work then you may need to drive a GPIO to being the part out of reset. - Steve _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
