Hi, Trevor and Amitay, Am Dienstag, den 22.04.2008, 07:38 +1000 schrieb Trevor Boon: > Hi Amitay, > > I specified the i2c_scan=1 option in my > /etc/modprobe.d/saa7134 file and the following > addresses were returned.. > > saa7130[0]: i2c scan: found device @ 0xa0 [eeprom] > saa7130[0]: i2c scan: found device @ 0xc0 [tuner > (analog)] > > Regards, > Trevor. > the 0x10 >> 1 for the digital demod is in the eeprom, if it follows usual rules, at least the tuner is correct there. Likely there are more possibilities, why the tda10048 does not appear, powered off for example to safe energy, but since you also had a crash previously, try a cold boot at first, means wait some time without any power connected, depending on capacitors of the mobo, but 30 seconds without any power should be always safe, and then just let it auto detect card=0 without a tuner again and let i2c_scan=1 enabled one more time. If still the same, you are likely above that basic testing step and can scratch heads on what doing next. Good Luck, Hermann _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
