Add a setting to config struct for inversion of lnb-voltage.
Needed for support of Avermedia A700 cards.
Signed-off-by: Matthias Schwarzott <zzam@xxxxxxxxxx>
Index: v4l-dvb/linux/drivers/media/dvb/frontends/mt312.c
===================================================================
--- v4l-dvb.orig/linux/drivers/media/dvb/frontends/mt312.c
+++ v4l-dvb/linux/drivers/media/dvb/frontends/mt312.c
@@ -422,11 +422,16 @@ static int mt312_set_voltage(struct dvb_
{
struct mt312_state *state = fe->demodulator_priv;
const u8 volt_tab[3] = { 0x00, 0x40, 0x00 };
+ u8 val;
if (v > SEC_VOLTAGE_OFF)
return -EINVAL;
- return mt312_writereg(state, DISEQC_MODE, volt_tab[v]);
+ val = volt_tab[v];
+ if (state->config->voltage_inverted)
+ val ^= 0x40;
+
+ return mt312_writereg(state, DISEQC_MODE, val);
}
static int mt312_read_status(struct dvb_frontend *fe, fe_status_t *s)
Index: v4l-dvb/linux/drivers/media/dvb/frontends/mt312.h
===================================================================
--- v4l-dvb.orig/linux/drivers/media/dvb/frontends/mt312.h
+++ v4l-dvb/linux/drivers/media/dvb/frontends/mt312.h
@@ -31,6 +31,9 @@
struct mt312_config {
/* the demodulator's i2c address */
u8 demod_address;
+
+ /* inverted voltage setting */
+ int voltage_inverted:1;
};
#if defined(CONFIG_DVB_MT312) || (defined(CONFIG_DVB_MT312_MODULE) && defined(MODULE))
--
_______________________________________________
linux-dvb mailing list
linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
