Amazing! I mentioned it yesterday, got it today. I recorded using a USB1.1 port on a mind blowing 133 MHz Via C3 computer! Tuner locks frequency very fast compared to my Hauppauge HVH-900. I included dmesg. The only odd message is: af9013: i2c write failed reg:ae00 val:02 Thanks a lot! /benoit [ 203.284000] usb 1-1: new full speed USB device using uhci_hcd and address 2 [ 203.468000] usb 1-1: configuration #1 chosen from 1 choice [ 203.468000] af9015_usb_probe: interface:0 [ 203.472000] af9015_identify_state: reply:01 [ 203.472000] dvb-usb: found a 'Afatech AF9015 DVB-T USB2.0 stick' in cold state, will try to load a firmware [ 204.060000] dvb-usb: downloading firmware from file 'dvb-usb-af9015.fw' [ 204.060000] af9015_download_firmware: [ 204.356000] af9015_usb_probe: interface:1 [ 204.356000] usb 1-1: USB disconnect, address 2 [ 204.356000] dvb-usb: generic DVB-USB module successfully deinitialized and disconnected. [ 204.356000] dvb-usb: generic DVB-USB module successfully deinitialized and disconnected. [ 204.628000] usb 1-1: new full speed USB device using uhci_hcd and address 3 [ 204.812000] usb 1-1: configuration #1 chosen from 1 choice [ 204.812000] af9015_usb_probe: interface:0 [ 204.816000] af9015_identify_state: reply:02 [ 204.816000] dvb-usb: found a 'Afatech AF9015 DVB-T USB2.0 stick' in warm state. [ 204.816000] dvb-usb: will use the device's hardware PID filter (table count: 32). [ 204.816000] DVB: registering new adapter (Afatech AF9015 DVB-T USB2.0 stick) [ 204.816000] af9015_eeprom_dump: [ 204.848000] 00: 2c 34 97 0b 00 00 00 00 a4 15 16 90 00 02 01 02 [ 204.880000] 10: 03 80 00 fa fa 10 40 ef 01 30 31 30 31 30 38 31 [ 204.912000] 20: 37 30 37 30 30 33 38 33 ff ff ff ff ff ff ff ff [ 204.944000] 30: 00 00 3a 01 00 08 02 00 1d 8d c4 04 82 ff ff ff [ 204.976000] 40: ff ff ff ff ff 08 02 00 1d 8d c4 04 82 ff ff ff [ 205.024000] 50: ff ff ff ff ff 24 00 00 04 03 09 04 10 03 41 00 [ 205.056000] 60: 66 00 61 00 74 00 65 00 63 00 68 00 0c 03 44 00 [ 205.088000] 70: 56 00 42 00 2d 00 54 00 20 03 30 00 31 00 30 00 [ 205.120000] 80: 31 00 30 00 31 00 30 00 31 00 30 00 36 00 30 00 [ 205.152000] 90: 30 00 30 00 30 00 31 00 00 ff ff ff ff ff ff ff [ 205.184000] a0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 205.216000] b0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 205.248000] c0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 205.280000] d0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 205.312000] e0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 205.344000] f0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 205.348000] af9015_read_config: xtal:2 set adc_clock:28000 [ 205.352000] af9015_read_config: IF1:36125 [ 205.356000] af9015_read_config: MT2060 IF1:1220 [ 205.356000] af9015_read_config: tuner id1:130 [ 205.360000] af9015_read_config: spectral inversion:0 [ 205.572000] af9013: firmware version:4.95.0 [ 205.572000] DVB: registering frontend 0 (Afatech AF9013 DVB-T)... [ 205.572000] af9015_tuner_attach: [ 205.572000] af9015_set_gpio: gpio:3 gpioval:03 [ 205.772000] MT2060: successfully identified (IF1 = 1220) [ 206.244000] dvb-usb: Afatech AF9015 DVB-T USB2.0 stick successfully initialized and connected. [ 206.244000] af9015_init: [ 206.244000] af9015_init_endpoint: USB speed:2 [ 206.264000] af9015_download_ir_table: [ 206.516000] af9015_usb_probe: interface:1 [ 206.524000] usbcore: registered new interface driver hiddev [ 206.532000] usbcore: registered new interface driver usbhid [ 206.532000] /build/buildd/linux-source-2.6.22-2.6.22/drivers/hid/usbhid/hid-core.c: v2.6:USB HID core driver [ 328.552000] af9015_pid_filter: set pid filter, index 0, pid fa1, onoff 1 [ 328.556000] af9015_pid_filter_ctrl: onoff:1 [ 328.560000] af9015_pid_filter: set pid filter, index 1, pid fa2, onoff 1 [ 329.568000] af9015: af9015_rw_udev: receiving failed: -110 [ 329.568000] af9013: i2c write failed reg:ae00 val:02 [ 339.252000] af9015_pid_filter: set pid filter, index 0, pid fa1, onoff 0 [ 339.268000] af9015_pid_filter: set pid filter, index 1, pid fa2, onoff 0 2008/4/8, Antti Palosaari <crope@xxxxxx>: > Antti Palosaari wrote: > > > Benoit Paquin wrote: > > > > > Antti, > > > Can you explain this? It would be neat if it worked with USB 1.1. There are several old laptops around that could be used as digital video recorder. The main stream vendors (Pinnacle, Hauppauge and ASUS) do not support USB 1.1. > > > > > > > AF9015 chipset does support USB1.1 but driver not. I haven't see this important enough to implement yet... It is rather easy to implement, lets see if I get inspirations soon ;) > > > > Implemented now. > > > regards > Antti > -- > http://palosaari.fi/ > _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
