Christoph Pfister wrote: > Hi, > > Can somebody please pick up those patches (descriptions inlined)? > > Thanks, > > Christoph Hi! I tried those patches, but got no picture and audio with my Terratec Cinergy 1200 DVB-C and TechniCAM CX Conax CAM (either FTA or scrambled). After modules loading dmesg output (I have 2 cards: DVB-T and DVB-C): b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip loaded successfully flexcop-pci: will use the HW PID filter. flexcop-pci: card revision 2 ACPI: PCI Interrupt 0000:02:02.0[A] -> GSI 17 (level, low) -> IRQ 20 DVB: registering new adapter (FlexCop Digital TV device) b2c2-flexcop: MAC address = 00:d0:d7:09:e0:87 b2c2-flexcop: i2c master_xfer failed b2c2-flexcop: i2c master_xfer failed b2c2-flexcop: found the mt352 at i2c address: 0x0f DVB: registering frontend 0 (Zarlink MT352 DVB-T)... b2c2-flexcop: initialization of 'Air2PC/AirStar 2 DVB-T' at the 'PCI' bus controlled by a 'FlexCopIIb' complete Linux video capture interface: v2.00 saa7146: register extension 'budget_av'. ACPI: PCI Interrupt 0000:02:01.0[A] -> GSI 22 (level, low) -> IRQ 22 saa7146: found saa7146 @ mem e0f26000 (revision 1, irq 22) (0x153b,0x1156). saa7146 (0): dma buffer size 192512 DVB: registering new adapter (Terratec Cinergy 1200 DVB-C) adapter failed MAC signature check encoded MAC from EEPROM was ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff KNC1-1: MAC addr = 00:0a:ac:11:00:21 TDA10021: i2c-addr = 0x0c, id = 0x7c DVB: registering frontend 1 (Philips TDA10021 DVB-C)... budget-av: ci interface initialised. budget-av: cam inserted A Now, when trying to run vdr it seems like loop in budget-av module: budget-av: cam inserted A DVB: TDA10021(1): _tda10021_writereg, writereg error (reg == 0x00, val == 0x73, ret == -121) dvb_ca adapter 1: DVB CAM detected and initialised successfully budget-av: cam inserted A dvb_ca adapter 1: DVB CAM detected and initialised successfully budget-av: cam inserted A dvb_ca adapter 1: DVB CAM detected and initialised successfully budget-av: cam inserted A dvb_ca adapter 1: DVB CAM detected and initialised successfully budget-av: cam inserted A dvb_ca adapter 1: DVB CAM detected and initialised successfully budget-av: cam inserted A dvb_ca adapter 1: DVB CAM detected and initialised successfully budget-av: cam inserted A dvb_ca adapter 1: DVB CAM detected and initialised successfully Corresponding log file: Mar 28 12:15:36 vdr kernel: budget-av: cam inserted A Mar 28 12:16:09 vdr last message repeated 9 times Any idea to fix this? Please... _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
