hi there,
i've a leadtek tv2000xp global pci card
it's running OK (with some errors, but works) with current developement
v4l-dvb branch
i tried to enable it's IR remote control too in cx88-input.c
just copied tv2000xp expert switch entry:
case CX88_BOARD_WINFAST2000XP_EXPERT:
ir_codes = ir_codes_winfast;
ir->gpio_addr = MO_GP0_IO;
ir->mask_keycode = 0x8f8;
ir->mask_keyup = 0x100;
ir->polling = 1; /* ms */
break;
but the result of this was: IR recognized well by kernel, dev/input
device attached
but when i pressed a button on remote, it printed its character, waited
a sec and started to repeat this character forever
so, i pressed '6', out was:
6<1sec_delay>666666666666666666666666666666666666666666666666666 .... etc..
could anybody help me to correct this?
it would be cool if i could paste a patch to the mailing list to enable
this functionality for this card
i figured out the main problem is with "ir->mask_keyup=0x100", so maybe
it isn't there... but i didnt find it at 0x60,0x80 too and don't know
where could it be??
ps: I also tried to comment out this line of code (as i saw some other
entrys without this option), the repeats are stopped but when i pressed
a button more than once it's only showed up once. So, i pressed 6,
printed 6 but when i pressed 6 again, it didnt print anything. After i
pressed other button (printed once too), and pressed again 6, prints 6
again).
Thanks for your help...
bye,
Szab
_______________________________________________
linux-dvb mailing list
linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
