Aah now I remember that issue, in fact it is no issue. I was seeing that problem when send the sleep command or any other firmware command without having a firmware running. In was, so far, no problem. Patrick. On Fri, 15 Feb 2008, Holger Dehnhardt wrote: > Hi Albert, Hi Mauro, > > I have successfulli patched and compiled the driver. Im using the terratec > cinergy device and it works fine. > >>> [ 2251.856000] xc2028 4-0061: Error on line 1063: -5 > > This error message looked very familar to me, so i searched my log and guess > what I found: > > Feb 15 20:42:18 musik kernel: xc2028 3-0061: xc2028_sleep called > Feb 15 20:42:18 musik kernel: xc2028 3-0061: xc2028_sleep called > Feb 15 20:42:18 musik kernel: xc2028 3-0061: Error on line 1064: -5 > Feb 15 20:42:18 musik kernel: DiB7000P: setting output mode for demod df75e800 > to 0 > Feb 15 20:42:18 musik kernel: DiB7000P: setting output mode for demod df75e800 > to 0 > > It identifies the marked line (just to be sure because of the differen line > numbers) > > if (priv->firm_version < 0x0202) > -> rc = send_seq(priv, {0x00, 0x08, 0x00, 0x00}); > else > rc = send_seq(priv, {0x80, 0x08, 0x00, 0x00}); > >> The above error is really weird. It seems to be related to something that >> happened before xc2028, since firmware load didn't start on that point of >> the code. > > The error really is weird, but it does not seem to cause the troubles - my > card works despite the error! > >> >>> [ 2289.284000] xc2028 4-0061: Device is Xceive 3028 version 1.0, firmware >>> version 2.7 >> >> This message means that xc3028 firmware were successfully loaded and it is >> running ok. > > This and the following messages look similar... > > Holger > > _______________________________________________ > linux-dvb mailing list > linux-dvb@xxxxxxxxxxx > http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb > _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb