Darron Broad pointed me to the patches available at http://dev.kewl.org/hauppauge/ (get the sfe version for the 1300). The patches applied cleanly about the v4l main tree mercurial source. That fixed the problem. both ir-kbd-i2c and lirc-i2c detect and initialize the IR receiver on the HVR1300 now. Thanks for your help Darron! Rajesh Rajesh Balan wrote: > forgot to add. I've tried the current hg sources of both the main v4l > repo and the hvr1300 specific repo. neither works. > > Rajesh > > Rajesh Balan wrote: > >> Hi, >> >> my new HVR-1300 is not being detected by the ir_kbd_i2c.ko module. I've >> tracked down the relevant info in the ir_probe component of the module. >> >> ir-kbd-i2c: in ir_probe. adap->id=40004 >> ir-kbd-i2c: in ir_probe. adap->id=1001b >> ir-kbd-i2cprobe 0x18 @ cx88[0]: no >> ir-kbd-i2cprobe 0x6b @ cx88[0]: no >> ir-kbd-i2cprobe 0x71 @ cx88[0]: no >> >> and then it exits. >> >> as for my card itself, it loads all the other modules fine. The >> intialization is exactly the same as shown at >> http://de.pastebin.ca/raw/891927 >> >> except that the ir-kbd-i2c parts are not there and this line is different >> >> tveeprom 0-0050: Hauppauge model 96019, rev C6A0, serial# 446394 >> >> my rev number is D6D3. >> >> What do I do to help debug this? >> >> Rajesh >> >> >> >> >> >> >> >> _______________________________________________ >> linux-dvb mailing list >> linux-dvb@xxxxxxxxxxx >> http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb >> >> >> > > > _______________________________________________ > linux-dvb mailing list > linux-dvb@xxxxxxxxxxx > http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb > > _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
