Hi Miguel Angel, Am Donnerstag, den 20.12.2007, 16:32 +0100 schrieb Miguel ÁngelFernández:> I'm sorry, I had sent this message directly to Hermann's e-mail instead of to the list.> I forward it again, I ask for excuses for this mistake. sorry too, I have a cold currently and did not even notice it. > > From: hermann> > Date: Tue, 18 Dec 2007 02:10:29 +0100> > > Holla,> Hello!> > > do you have to do anything actively?> No I don't. It's automatically detected. Fine! > > > > It is a dual tuner device and what about the remote so far?> It has a digital tuner and an analogue tuner. You can watch 1 dvb-t channel + 1 analogue channel at> the same time. But it is not posible to see 2 dvb-t channels at the same time or 2 analogue channels.> > Sorry, about the remote I can't tell you anything because I don't know how to configure it. It should have a KS700 i2c remote controller then. There is a patch around from Dwaine Garden for the Kworld ATSC110 basedon a patch by Henry Wong for the MSI TV@nywhere with KS300. > > > > Please send us "dmesg" for the saa713x and tuner stuff.> [ 24.468000] saa7130/34: v4l2 driver version 0.2.14 loaded> [ 24.468000] ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 11> [ 24.468000] ACPI: PCI Interrupt 0000:00:0d.0[A] -> Link [LNKC] -> GSI 11 (level, low) -> IRQ 11> [ 24.468000] saa7133[0]: found at 0000:00:0d.0, rev: 209, irq: 11, latency: 32, mmio: 0xde001000> [ 24.468000] saa7133[0]: subsystem: 17de:7201, board: Tevion/KWorld DVB-T 220RF [card=88,autodetected]> [ 24.468000] saa7133[0]: board init: gpio is 100> [ 24.604000] saa7133[0]: i2c eeprom 00: de 17 01 72 ff ff ff ff ff ff ff ff ff ff ff ff> [ 24.604000] saa7133[0]: i2c eeprom 10: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff> [ 24.604000] saa7133[0]: i2c eeprom 20: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff> [ 24.604000] saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff> [ 24.604000] saa7133[0]: i2c eeprom 40: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff> [ 24.604000] saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff> [ 24.604000] saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff> [ 24.604000] saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff> [ 25.212000] tuner 1-004b: chip found @ 0x96 (saa7133[0])> [ 25.260000] tuner 1-004b: setting tuner address to 61> [ 25.308000] tuner 1-004b: type set to tda8290+75a> [ 25.592000] parport_pc 00:0a: reported by Plug and Play ACPI> [ 25.592000] parport0: PC-style at 0x378 (0x778), irq 7, dma 3 [PCSPP,TRISTATE,COMPAT,EPP,ECP,DMA]> [ 25.804000] pnp: Device 01:01.02 activated.> [ 25.824000] gameport: NS558 PnP Gameport is pnp01:01.02/gameport0, io 0x200, speed 438kHz> [ 27.092000] tuner 1-004b: setting tuner address to 61> [ 27.132000] tuner 1-004b: type set to tda8290+75a> [ 28.452000] saa7133[0]: registered device video0 [v4l2]> [ 28.456000] saa7133[0]: registered device vbi0> [ 28.456000] saa7133[0]: registered device radio0> [ 28.544000] ACPI: PCI Interrupt 0000:00:0f.0[A] -> Link [LNKD] -> GSI 11 (level, low) -> IRQ 11> [ 28.744000] saa7134 ALSA driver for DMA sound loaded> [ 28.744000] saa7133[0]/alsa: saa7133[0] at 0xde001000 irq 11 registered as card -2> [ 28.812000] DVB: registering new adapter (saa7133[0]).> [ 28.812000] DVB: registering frontend 0 (Philips TDA10046H DVB-T)...> [ 28.920000] tda1004x: setting up plls for 48MHz sampling clock> [ 29.204000] tda1004x: found firmware revision 29 -- ok> [ 30.968000] lp0: using parport0 (interrupt-driven).> [ 31.068000] Adding 939792k swap on /dev/hda3. Priority:-1 extents:1 across:939792k> [ 31.708000] EXT3 FS on hda2, internal journal> [ 33.060000] NET: Registered protocol family 10> [ 33.060000] lo: Disabled Privacy Extensions> [ 43.608000] eth0: no IPv6 routers present> [ 47.308000] No dock devices found.> [ 47.556000] input: Power Button (FF) as /class/input/input4> [ 47.556000] ACPI: Power Button (FF) [PWRF]> [ 47.604000] input: Power Button (CM) as /class/input/input5> [ 47.604000] ACPI: Power Button (CM) [PWRB]> [ 47.628000] input: Sleep Button (CM) as /class/input/input6> [ 47.628000] ACPI: Sleep Button (CM) [SLPB]> [ 61.244000] ppdev: user-space parallel port driver> [ 71.412000] audit(1198074711.646:3): type=1503 operation="inode_permission" requested_mask="a" denied_mask="a" name="/dev/tty" pid=4753 profile="/usr/sbin/cupsd"> [ 88.308000] tda1004x: setting up plls for 48MHz sampling clock> [ 88.592000] tda1004x: found firmware revision 29 -- ok> Seems all fine, will have a closer look after Christmas. > > > > > Thanks for your report!> It is the minimal thing that I can do for the community Thanks again, Hermann _______________________________________________linux-dvb mailing listlinux-dvb@xxxxxxxxxxxxxxx://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
