Il Thursday 25 October 2007 04:07:19 Hong Yin Lim ha scritto: > Hi, > > I've tried to use the following command to capture the TS from a > DVB-C card: > > $ dvbstream -f 594000 -s 6875 -0 8192 > test.ts > > However, I get the follwoing result: > > *dvbstream v0.7 - (C) Dave Chapman 2001-2004 > **Released under the GPL. > **Latest version available from http://www.linuxstb.org/ > Adding whole transport stream to map n . 0 > **Open file test.ts > **Tuning to 594000 Hz > **Using DVB card "ST STV0297 DVB-C", freq=594000 > **tuning DVB-C to 594000000, srate=6875000 > **Getting frontend status > **Not able to lock to the signal on the given frequency > **MAP 0, file test.ts: From -1 secs, To -1 secs, 2 PIDs - 0 8192 > **dvbstream will stop after -1 seconds (71582788 minutes) > **Streaming 1 stream* > > > Where did I went wrong? > > I've tried using czap to lock into the channels, & it works.. > > > Thank you. > > > Regards, > hy try to raise the timeout value in tune.c _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
