I am new to this whole dvb thing.
Basically, I want to capture the TS off the tv-tuner card (DVB-C).
I have successfully used the czap & scan to get the channels configuration.
After that, I "make" the dvbstream: & run it to capture the TS off the card as follows:
> dvbstream 8192 -o > test.ts
However in my output I get:
dvbstream v0.5 - (C) Dave Chapman 2001-2004I noticed from other discussions that the normal output would have something like this:
Released under the GPL.
Latest version available from http://www.linuxstb.org/
Setting filter for PID 8192
Output to stdout
Streaming 1 stream
Caught signal 2 - closing cleanly.
where the captured ts file: test.ts is 0 bytes.
Using DVB card "ST STV0297 DVB-C"
tuning DVB-C to 618000000, srate=XXXX000
polling....
Getting frontend event
FE_STATUS:
polling....
Getting frontend event
FE_STATUS: FE_HAS_SIGNAL FE_HAS_LOCK FE_HAS_CARRIER FE_HAS_VITERBI
FE_HAS_SYNC
Event: Frequency: 628600000
SymbolRate: XXXX000
FEC_inner: 0
Bit error rate: 0
Signal strength: 546
SNR: 1433
FE_STATUS:
However, I do not have any of this.
Where did I went wrong?
Thank you.
Reagrds,
hy
_______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
