> Simon Baxter wrote: >> Hi >> >> I have a new TT-2300 DVB-C FF card with the associated CI module with >> in-built IR receiver. >> >> The IR seems to register fine: >> dmesg: >> input: DVB on-card IR receiver as /class/input/input3 > > It always registers, no matter whether there is an ir receiver or not. oh, ok! >> ...and I've added the little jumper on the CI - but it won't work. >> >> I do a 'tail -f /dev/input/event3' and get nothing when pointing the >> remote >> at it. > > This will only work if you have loaded a keymap. This isn't something I've done before - always used serial homebrew and LIRC >> Similarly get nothing with VDR and the vdr-remote plugin. >> >> Any ideas??? > > Is the IR receiver connected to the card or to the CI? The IR receiver is on the front of the CI module, and there's a jumper on the back of the CI - which I've connected. > From remote plugin FAQ: > | 2.2.1 The remote control does not work, if a CI is connected > | ------------------------------------------------------ > | Whenever a CI is connected, the on-board connector will be disabled! > | > | On some CIs there is a jumper to select whether the receiver of the CI > | or the receiver of the FF-card should be used. RTFM. > | > | If not, use the integrated receiver of the CI, > | or connect the receiver to the ir connector of the CI. > > Another solution posted by loannis@vdr-portal: > http://www.vdr-portal.de/board/thread.php?postid=652902#post652902 > (Remove the 0 Ohm resistor.) A full English manual of the C-2300 and CI would be useful!! _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
