Simon Baxter wrote: > Hi > > I have a new TT-2300 DVB-C FF card with the associated CI module with > in-built IR receiver. > > The IR seems to register fine: > dmesg: > input: DVB on-card IR receiver as /class/input/input3 It always registers, no matter whether there is an ir receiver or not. > ...and I've added the little jumper on the CI - but it won't work. > > I do a 'tail -f /dev/input/event3' and get nothing when pointing the remote > at it. This will only work if you have loaded a keymap. > Similarly get nothing with VDR and the vdr-remote plugin. > > Any ideas??? Is the IR receiver connected to the card or to the CI? >From remote plugin FAQ: | 2.2.1 The remote control does not work, if a CI is connected | ------------------------------------------------------ | Whenever a CI is connected, the on-board connector will be disabled! | | On some CIs there is a jumper to select whether the receiver of the CI | or the receiver of the FF-card should be used. RTFM. | | If not, use the integrated receiver of the CI, | or connect the receiver to the ir connector of the CI. Another solution posted by loannis@vdr-portal: http://www.vdr-portal.de/board/thread.php?postid=652902#post652902 (Remove the 0 Ohm resistor.) CU Oliver -- ---------------------------------------------------------------- VDR Remote Plugin 0.4.0: http://www.escape-edv.de/endriss/vdr/ ---------------------------------------------------------------- _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
