Hi, I've notice the same thing with my Kworld ATSC-110. I'm running Ubuntu 7.10, 2.6.22-10-generic, x86_64. I guess it is a change in the 2.6.22 kernel. Is there anyway to change this back so that QAM and NTSC inputs are the same? Thank you, Nathan. -----Original Message----- From: linux-dvb-bounces@xxxxxxxxxxx [mailto:linux-dvb-bounces@xxxxxxxxxxx] On Behalf Of Eric Sandeen Sent: Saturday, August 25, 2007 7:29 PM To: linux-dvb@xxxxxxxxxxx Subject: Re: cx88-dvb: fix nxt200x rf input switching broke my tuner? :) Eric Sandeen wrote: > hi, I have a Kworld ATSC 110 PCI DVB card, > > 03:09.0 Multimedia controller: Philips Semiconductors SAA7133/SAA7135 > Video Broadcast Decoder (rev f0) > Subsystem: KWorld Computer Co. Ltd. ATSC 110 Digital / Analog > HDTV Tuner > Flags: bus master, medium devsel, latency 55, IRQ 23 > Memory at c4001000 (32-bit, non-prefetchable) [size=2K] > Capabilities: [40] Power Management version 2 > > It seems this fairly recent mod broke my ability to tune in QAM HDTV: > > --- > > http://git.kernel.org/?p=linux/kernel/git/torvalds/linux-2.6.git;a=com > mitdiff;h=f5ae29e284b328e0976789d5c199bbbe80e4b005 > [PATCH] cx88-dvb: fix nxt200x rf input switching Michael Krufky [Sat, > 24 Mar 2007 17:21:53 +0000 (13:21 -0400)] After dvb tuner refactoring, > the pllbuff has been altered such that the pll address is now stored > in buf[0]. Instead of sending buf to set_pll_input, we should send > buf+1. > > --- Ok, after much patient assistance from mkrufky, we sorted out that a recent change meant that I had to switch physical inputs on my card - that is, plugging the physical cable into the *other* card input (the input closer to the center of pci card bracket) - makes everything happy again... Thanks, -Eric _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
