Thanks Jan, I hadn't spotted that, but it makes no difference - even when I add "options saa7134 card=72" I get: > saa7130[0]: found at 0000:00:0c.0, rev: 1, irq: 19, latency: 32, mmio: 0xe2000000 > saa7130[0]: subsystem: 185b:c901, board: RTD Embedded Technologies VFG7350 [card=72,insmod option] > saa7130[0]: board init: gpio is 853f43 > saa7130[0]: i2c eeprom 00: 5b 18 01 c9 54 20 1c 00 43 43 a9 1c 55 d2 b2 92 > saa7130[0]: i2c eeprom 10: 00 ff 86 0f ff 20 ff ff ff ff ff ff ff ff ff ff > saa7130[0]: i2c eeprom 20: 01 40 01 03 03 ff 03 01 08 ff 00 88 ff ff ff ff > saa7130[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > saa7130[0]: i2c eeprom 40: ff d5 00 c4 86 1e ff ff ff ff ff ff ff ff ff ff > saa7130[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff cb > saa7130[0]: i2c eeprom 60: 30 ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > saa7130[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > saa7130[0]: registered device video0 [v4l2] > saa7130[0]: registered device vbi0 > saa7130[0]: registered device video1 [mpeg] - but no /dev/dvb or anything below it. relevant modules seem to be saa7134, saa7134-dvb, saa7134-empress and mt352. Anything missing? Any more ideas please? Anyone?! -- Cheers Richard (MQ) Jan D. Louw wrote: > Hi Richard, > > Looks like your card is forced to the wrong card number. The T200 is > supposed to be auto detected as card #71, but yours was forced to #72 > (insmod option). Check your /etc/modprobe.conf or similar file for > something like a 'option saa7134 card=72' statement. > > Regards > JD > > Richard (MQ) wrote: >> Jan, >> >> This is what dmesg has to say about the card on boot: >> >>> shpchp: Standard Hot Plug PCI Controller Driver version: 0.4 >>> saa7130/34: v4l2 driver version 0.2.14 loaded >>> ACPI: PCI Interrupt 0000:00:0c.0[A] -> GSI 16 (level, low) -> IRQ 19 >>> saa7130[0]: found at 0000:00:0c.0, rev: 1, irq: 19, latency: 32, mmio: 0xe2000000 >>> saa7130[0]: subsystem: 185b:c901, board: RTD Embedded Technologies VFG7350 [card=72,insmod option] >>> saa7130[0]: board init: gpio is 843f00 >>> saa7130[0]: i2c eeprom 00: 5b 18 01 c9 54 20 1c 00 43 43 a9 1c 55 d2 b2 92 >>> saa7130[0]: i2c eeprom 10: 00 ff 86 0f ff 20 ff ff ff ff ff ff ff ff ff ff >>> saa7130[0]: i2c eeprom 20: 01 40 01 03 03 ff 03 01 08 ff 00 88 ff ff ff ff >>> saa7130[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff >>> saa7130[0]: i2c eeprom 40: ff d5 00 c4 86 1e ff ff ff ff ff ff ff ff ff ff >>> saa7130[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff cb >>> saa7130[0]: i2c eeprom 60: 30 ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff >>> saa7130[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff >>> tuner 1-0062: chip found @ 0xc4 (saa7130[0]) >>> tuner 1-0062: type set to 1 (Philips PAL_I (FI1246 and compatibles)) >>> tuner 1-0062: type set to 1 (Philips PAL_I (FI1246 and compatibles)) >>> tuner 1-0063: chip found @ 0xc6 (saa7130[0]) >>> tuner 1-0068: chip found @ 0xd0 (saa7130[0]) >>> saa7130[0]: registered device video0 [v4l2] >>> saa7130[0]: registered device vbi0 >>> ACPI: PCI Interrupt Link [ALKC] BIOS reported IRQ 0, using IRQ 22 >>> ACPI: PCI Interrupt Link [ALKC] enabled at IRQ 22 >>> ACPI: PCI Interrupt 0000:00:11.5[C] -> Link [ALKC] -> GSI 22 (level, low) -> IRQ 20 >>> PCI: Setting latency timer of device 0000:00:11.5 to 64 >>> saa7130[0]: registered device video1 [mpeg] >> and lsmod (edited): >> >>> saa7134_empress 25860 0 >>> snd_via82xx 43800 0 >>> saa6752hs 26508 0 >>> tuner 73640 0 >>> snd_ac97_codec 109220 1 snd_via82xx >>> ac97_bus 18560 1 snd_ac97_codec >>> snd_pcm 94212 3 snd_pcm_oss,snd_via82xx,snd_ac97_codec >>> snd_timer 38788 2 snd_seq,snd_pcm >>> snd_page_alloc 26248 2 snd_via82xx,snd_pcm >>> saa7134 137164 1 saa7134_empress >>> shpchp 47380 0 >>> pci_hotplug 45504 1 shpchp >>> snd_mpu401 25100 0 >>> snd_mpu401_uart 24704 2 snd_via82xx,snd_mpu401 >>> snd_rawmidi 40320 2 snd_seq_midi,snd_mpu401_uart >>> video_buf 39940 2 saa7134_empress,saa7134 >>> snd_seq_device 24460 3 snd_seq_midi,snd_seq,snd_rawmidi >>> compat_ioctl32 17664 1 saa7134 >>> ir_kbd_i2c 24976 1 saa7134 >>> ir_common 50436 2 saa7134,ir_kbd_i2c >>> videodev 42752 2 saa7134_empress,saa7134 >>> v4l2_common 32896 4 saa7134_empress,tuner,saa7134,videodev >>> v4l1_compat 28676 2 saa7134,videodev >>> i2c_core 39808 5 saa6752hs,tuner,saa7134,ir_kbd_i2c,i2c_viapro >> I have an MT352 on the board - it's clearly marked - but no sign of a >> module for it? Unless saa6752hs is something to do with it? >> >> As you say, we both need someone more knowledgeable to comment on this... >> > > _______________________________________________ > linux-dvb mailing list > linux-dvb@xxxxxxxxxxx > http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb > > _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
