--- Michael Krufky <mkrufky@xxxxxxxxxxx> wrote: > David Findlay wrote: > >> If you could find a photo of it, that would help. Worst case scenario, I > >> can send you a patch to enable the IR, and you may have to program the > >> remote keymap (We already have keymaps ready for 1, 2, and 3 -- only 4 > >> needs programming, but I have that one here, and plan to take care of it > >> over the weekend) > > > > http://www.davsoft.com.au/remote1.jpg > > http://www.davsoft.com.au/remote2.jpg <- shows the ir receiver which looks > > more like an IR led to me. > > Perfect! I took the right guess -- the remote shown above is the MCE remote. > This patch should do the trick: > > http://linuxtv.org/~mkrufky/pending/xc/bluebird2-ir.patch > > Please provide some feedback -- let me know whether or not this works. > > Cheers, > > Mike Thanks for providing the pics David. I can confirm that is what my remote and receiver look like. Mike, thank you for the patch. I've applied it and I now have 2 new /dev/input/ event entries, 3 & 4: [17179588.964000] dvb-usb: found a 'DViCO FusionHDTV DVB-T Dual Digital 4' in warm state. [17179588.964000] dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer. <wifi and video card stuff removed> [17179589.812000] DVB: registering frontend 0 (Zarlink ZL10353 DVB-T)... [17179589.844000] input: IR-receiver inside an USB DVB receiver as /class/input/input3 [17179589.844000] dvb-usb: schedule remote query interval to 150 msecs. [17179589.844000] dvb-usb: DViCO FusionHDTV DVB-T Dual Digital 4 successfully initialized and connected. [17179589.844000] dvb-usb: found a 'DViCO FusionHDTV DVB-T Dual Digital 4' in warm state. [17179589.844000] dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer. [17179589.876000] DVB: registering new adapter (DViCO FusionHDTV DVB-T Dual Digital 4). [17179590.164000] DVB: registering frontend 1 (Zarlink ZL10353 DVB-T)... [17179590.164000] input: IR-receiver inside an USB DVB receiver as /class/input/input4 [17179590.164000] dvb-usb: schedule remote query interval to 150 msecs. [17179590.164000] dvb-usb: DViCO FusionHDTV DVB-T Dual Digital 4 successfully initialized and connected. [17179590.164000] usbcore: registered new driver dvb_usb_cxusb However when I try to use them nothing happens. I have tried "cat /dev/input/event3" and "irrecord --driver=dev/input --device=/dev/input/event3 bob.txt", but pressing buttons does nothing. The green led on the remote goes on when I press a button. With irrecord I get the following output after pressing RETURN and holding a button for a few seconds: Hold down an arbitrary button. irrecord: gap not found, can't continue irrecord: closing '/dev/input/event3' I also tried with event4. Petey. ____________________________________________________________________________________ Yahoo!7 Mail has just got even bigger and better with unlimited storage on all webmail accounts. http://au.docs.yahoo.com/mail/unlimitedstorage.html _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
