Michel Verbraak wrote: > Zoilo Gomez schreef: >> Manu Abraham wrote: >>> Zoilo Gomez wrote: >>> >>>> Manu Abraham wrote: >>>> >>>>> Zoilo Gomez wrote: >>>>> >>>>> >>>>>> Manu Abraham wrote: >>>>>> >>>>>>> Michel Verbraak wrote: >>>>>>> >>>>>>> >>>>>>>> Manu, list, >>>>>>>> >> <SNIP> >> Freq+symrate is correct; I tried several freqs / pols / symbol rates >> on sat=2. >> >> I am quite sure that the problem is simple and diseqc related, for the >> several reasons: >> >> => my normal sat receiver is working fine on all 16 sat feeds (4*4) >> >> => KNC1 DVB-C is also working fine on all sats / pols / bands; the >> fact that it is capable to select different sats proves that its >> diseqc commands are working. >> >> => however VP1034 is working only on first satellite (out of 4). This >> seems to be caused by 18/13V+22kHz signaling (not diseqc), which is >> applied simultaneously with the diseqc command. However, switching to >> a different sat is impossible, because diseqc is not working. In fact, >> if I use the very same freq+pol+symrate, but only change the sat >> number (f.e. sat=2 of sat=3), I get the exact same transport stream >> from sat=1. So no sat switching occurs, hence diseqc is apparently not >> working, and 18/13V+22kHz must be responsible for pol+band selection. >> >>> Can't see the bug from a quick glance, will take a look at it, these >>> days. >>> >> >> Please let me know where I can help. >> >> Z. > Zoilo and Manu, > > DiseqC is working for me with my own programs and the patch i made for > libdvbsec. > I only use the GotoX function. Not preprogrammed positions. > When I have time again I will have a look into this. > Michel, Thanks. Ok, so DiSEqC with regards to the MB86A16 works > When I tried the latest version of kaffeine, it now supports rotors, it > was not able to rotate my rotor with kaffeine. I did not yet spend time > to look into this because my own software still works. > > I can send you a small c-program which I made to rotate the rotor, by > angle, I can send it or make it available trough a website. Please let > me know. It uses my patched libdvbsec. As far as I know my patch is not > implemented yet (do not know why). You did send your patch ? _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
