--- Begin Message ---
Hartmut Hackmann ha scritto:
If kaffeine works but xine and scan not, the reason lies in your initial
tuning file. If channel parameters - i.e. the guard interval - are wrong,
the tda10046 won't lock. This can easily be the case since some other
drivers just ignore these values.
Thanks, i replaced "AUTO" with correct value of QAM FEC...infact the
output produced by "scan .... >> channels.conf" now works with xine and
mplayer
with almost all channel. On the other hand, scan find a large number of
channel that i can't view with xine/mplayer and i think
that this is due to poor signal of this channels or maybe problem is
antenna. I don't know if it is a board problem.
From now i view 50% (*the very most important*) of all 60 channels.
This is still the old firmware. Sorry, i didn't mention this:
Depending on the card wiring, you either need to reload the saa7134 and
saa7134-dvb module or even do a power cycle to get the new firmware
loaded.
okay... sorry for my inexperience...
the result now is this :
tda1004x: setting up plls for 48MHz sampling clock
tda1004x: found firmware revision 29 -- ok
i think it shoud be correct.
>>tda827x: tda8275a AGC2 gain is: 10 <<-- this message all time scanning
Thats ok. If debugging is on, this message occurs at every tuning attempt.
BTW: this is maximum gain, is your antenna energy low?
i don't know about energy low.. i use normally an terrestrial antenna
like this : http://personal.inet.fi/cool/lwgt/myoldvdr/uhf-antenna.jpg
but i try to use also a mobile antenna similar to this one :
http://www.3dnews.ru/documents/10598/Antenna.jpg
with the mobile antenna results are very very bad... but the message
about gain is the same in both case.
Thanks a lot for the offer, i will come back on this.
no problem u're welcome.
Can you please follow the hints i gave you before we continue?
I hope that's you're request are satisfied, i'm not sure that i have
done the right thing that u have requested :)
my english is not perfect and many times i don't understand perfectly
what people want or say. .)
Best regards
Hartmut
ciaooo
kev
--- End Message ---
_______________________________________________
linux-dvb mailing list
linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
