I have the Twinhan DTV Ter 3028 and have downloaded the mantis.tar.bz2. I compiled and installed the drivers under 2.6.17 (Ubuntu Edgy). That much went fine.
The problem is that no frontend is found in the /dev/dvb/adapter directory. Is this card supported? Does anyone know which frontend should be in use?
lspci -vv gives:
02:02.0 Multimedia controller: Twinhan Technology Co. Ltd Mantis DTV PCI Bridge Controller [Ver 1.0] (rev 01)
Subsystem: Twinhan Technology Co. Ltd Unknown device 0028
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 32 (2000ns min, 63750ns max)
Interrupt: pin A routed to IRQ 3
Region 0: Memory at ec000000 (32-bit, prefetchable) [size=4K]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
This is the dmesg from when DVB is loaded to the last DVB related message:
[17179583.528000] Linux video capture interface: v2.00
[17179584.008000] saa7146: register extension 'budget dvb'.
[17179584.008000 ] ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 4
[17179584.008000] PCI: setting IRQ 4 as level-triggered
[17179584.008000] ACPI: PCI Interrupt 0000:02:01.0[A] -> Link [LNKC] -> GSI 4 (level, low) -> IRQ 4
[17179584.008000] saa7146: found saa7146 @ mem f8904000 (revision 1, irq 4) (0x13c2,0x1005).
[17179584.008000] saa7146 (0): dma buffer size 192512
[17179584.008000] DVB: registering new adapter (TT-Budget/WinTV-NOVA-T PCI).
[17179584.044000] adapter has MAC addr = 00:d0:5c:21:2a:b6
[17179584.108000] bttv: driver version 0.9.16 loaded
[17179584.108000] bttv: using 8 buffers with 2080k (520 pages) each for capture
[17179584.120000 ] DVB: registering frontend 0 (LSI L64781 DVB-T)...
[17179584.120000] bttv: Bt8xx card found (0).
[17179584.120000] ACPI: PCI Interrupt Link [LNKF] enabled at IRQ 7
[17179584.120000] PCI: setting IRQ 7 as level-triggered
[17179584.120000] ACPI: PCI Interrupt 0000:02:03.0[A] -> Link [LNKF] -> GSI 7 (level, low) -> IRQ 7
[17179584.120000] bttv0: Bt878 (rev 17) at 0000:02:03.0, irq: 7, latency: 32, mmio: 0xec001000
[17179584.120000 ] bttv0: detected: Twinhan VisionPlus DVB [card=113], PCI subsystem ID is 1822:0001
[17179584.120000] bttv0: using: Twinhan DST + clones [card=113,autodetected]
[17179584.120000] bttv0: gpio: en=00000000, out=00000000 in=00f3edfe [init]
[17179584.120000] bttv0: using tuner=4
[17179584.148000] bttv0: add subdevice "dvb0"
[17179584.148000] bttv: Bt8xx card found (1).
[17179584.148000] ACPI: PCI Interrupt Link [LNK0] enabled at IRQ 5
[17179584.148000] PCI: setting IRQ 5 as level-triggered
[17179584.148000] ACPI: PCI Interrupt 0000:02:04.0[A] -> Link [LNK0] -> GSI 5 (level, low) -> IRQ 5
[17179584.148000] bttv1: Bt878 (rev 17) at 0000:02: 04.0, irq: 5, latency: 32, mmio: 0xec003000
[17179584.148000] bttv1: detected: Twinhan VisionPlus DVB [card=113], PCI subsystem ID is 1822:0001
[17179584.148000] bttv1: using: Twinhan DST + clones [card=113,autodetected]
[17179584.148000] bttv1: gpio: en=00000000, out=00000000 in=00f3edfe [init]
[17179584.148000] bttv1: using tuner=4
[17179584.164000] bttv1: add subdevice "dvb1"
[17179584.164000] ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 10
[17179584.164000] PCI: setting IRQ 10 as level-triggered
[17179584.164000] ACPI: PCI Interrupt 0000:02:00.0[A] -> Link [LNKB] -> GSI 10 (level, low) -> IRQ 10
[17179584.164000] 3c59x: Donald Becker and others. www.scyld.com/network/vortex.html
[17179584.164000] 0000:02:00.0: 3Com PCI 3c905C Tornado at f8b16000.
[17179584.188000] ACPI: PCI Interrupt Link [LNKD] enabled at IRQ 3
[17179584.188000] PCI: setting IRQ 3 as level-triggered
[17179584.188000] ACPI: PCI Interrupt 0000:02:02.0[A] -> Link [LNKD] -> GSI 3 (level, low) -> IRQ 3
[17179584.188000] Mantis Rev 1, irq: 3, latency: 32
[17179584.188000] memory: 0xec000000, mmio: 0xf8966000
[17179584.240000] sd 0:0:0:0: Attached scsi generic sg0 type 0
[17179584.244000] sd 0:0:1:0: Attached scsi generic sg1 type 0
[17179584.256000] bt878: AUDIO driver version 0.0.0 loaded
[17179584.264000] ACPI: PCI Interrupt 0000:02:00.0[A] -> Link [LNKB] -> GSI 10 (level, low) -> IRQ 10
[17179584.268000] eth0: setting full-duplex.
[17179584.356000] get_mac_address (1): MAC Address=[00:08:ca:00:00:00]
[17179584.428000] get_subvendor_id (1): Sub Vendor ID=[0x1822]
[17179584.500000] get_subdevice_id (1): Sub Device ID=[0x0028]
[17179584.500000] mantis_alloc_buffers (1): DMA=0x37a20000 cpu=0xf7a20000 size=65536
[17179584.500000] mantis_alloc_buffers (1): RISC=0x190a000 cpu=0xc190a000 size=1000
[17179584.500000] DVB: registering new adapter (Mantis dvb adapter).
[17179584.628000] NET: Registered protocol family 10
[17179584.628000 ] lo: Disabled Privacy Extensions
[17179584.628000] IPv6 over IPv4 tunneling driver
[17179585.020000] bt878: Bt878 AUDIO function found (0).
[17179585.020000] ACPI: PCI Interrupt 0000:02:03.1[A] -> Link [LNKF] -> GSI 7 (level, low) -> IRQ 7
[17179585.020000] bt878_probe: card id=[0x11822],[ Twinhan VisionPlus DVB ] has DVB functions.
[17179585.020000] bt878(0): Bt878 (rev 17) at 02:03.1, irq: 7, latency: 32, memory: 0xec002000
[17179585.020000] bt878: Bt878 AUDIO function found (1).
[17179585.020000] ACPI: PCI Interrupt 0000:02:04.1[A] -> Link [LNK0] -> GSI 5 (level, low) -> IRQ 5
[17179585.020000] bt878_probe: card id=[0x11822],[ Twinhan VisionPlus DVB ] has DVB functions.
[17179585.020000 ] bt878(1): Bt878 (rev 17) at 02:04.1, irq: 5, latency: 32, memory: 0xec004000
[17179585.300000] Non-volatile memory driver v1.2
[17179585.324000] DVB: registering new adapter (bttv0).
[17179585.616000] dst(0) dst_get_device_id: Recognise [DST-03T]
[17179585.652000] dst(0) dst_check_stv0299: Found a STV0299 NIM
[17179585.688000] dst(0) dst_check_mb86a15: Found a MB86A15 NIM
[17179585.688000] dst(0) dst_get_device_id: [DST-03T] has a [MB 86A15]
[17179585.688000 ] dst(0) dst_get_device_id: [DST-03T] has a [MB 86A15]
[17179585.688000] DST type flags : 0x2 ts204 0x4 symdiv 0x10 firmware version = 2
[17179585.724000] dst(0) dst_get_mac: MAC Address=[00:08:ca:00:00:00]
[17179585.724000 ] DVB: registering frontend 2 (DST DVB-S)...
[17179585.728000] DVB: registering new adapter (bttv1).
[17179585.992000] dst(1) dst_get_device_id: Recognise [DST-03T]
[17179586.028000] dst(1) dst_check_stv0299: Found a STV0299 NIM
[17179586.064000] dst(1) dst_check_mb86a15: Found a MB86A15 NIM
[17179586.064000] dst(1) dst_get_device_id: [DST-03T] has a [MB 86A15]
[17179586.064000] dst(1) dst_get_device_id: [DST-03T] has a [MB 86A15]
[17179586.064000 ] DST type flags : 0x2 ts204 0x4 symdiv 0x10 firmware version = 2
[17179586.100000] dst(1) dst_get_mac: MAC Address=[00:08:ca:00:00:00]
[17179586.100000] DVB: registering frontend 3 (DST DVB-S)...
Regards,
Simeon
_______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
