I have successfully installed kernel 2.6.20 and the v4l cvs driver to get my Twinhan Starbox 2 running. But when loading the module i get an error: Linux video capture interface: v2.00 saa7146: register extension 'dvb'. usb 2-1: new full speed USB device using ohci_hcd and address 2 usb 2-1: not running at top speed; connect to a high speed hub usb 2-1: configuration #1 chosen from 1 choice dvb-usb: found a 'TwinhanDTV StarBox DVB-S USB2.0 (VP7021)' in cold state, will try to load a firmware dvb-usb: downloading firmware from file 'dvb-usb-vp702x-02.fw' usb 2-1: USB disconnect, address 2 dvb-usb: found a 'TwinhanDTV StarBox DVB-S USB2.0 (VP7021)' in warm state. dvb-usb: This USB2.0 device cannot be run on a USB1.1 port. (it lacks a hardware PID filter) dvb-usb: TwinhanDTV StarBox DVB-S USB2.0 (VP7021) error while loading driver (-19) usbcore: registered new interface driver dvb_usb_vp702x usb 3-2: new high speed USB device using ehci_hcd and address 4 usb 3-2: configuration #1 chosen from 1 choice dvb-usb: found a 'TwinhanDTV StarBox DVB-S USB2.0 (VP7021)' in cold state, will try to load a firmware dvb-usb: downloading firmware from file 'dvb-usb-vp702x-02.fw' dvb-usb: found a 'TwinhanDTV StarBox DVB-S USB2.0 (VP7021)' in warm state. dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer. DVB: registering new adapter (TwinhanDTV StarBox DVB-S USB2.0 (VP7021)). dvb-usb: MAC address: 00:08:ca:15:88:c7 vp702x: system string: USB702X< DVB: registering frontend 0 (Twinhan DST-like frontend (VP7021/VP7020) DVB-S)... input: IR-receiver inside an USB DVB receiver as /class/input/input1 dvb-usb: schedule remote query interval to 400 msecs. dvb-usb: TwinhanDTV StarBox DVB-S USB2.0 (VP7021) successfully initialized and connected. Can anybody help here ? Regards Hubert _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
