On Wed, 13 Dec 2006 02:41:19 +0200 Antti Palosaari <crope@xxxxxx> wrote: > hei! > changes: > QT1010: > - old qt1010-code totally rewritten and put in own kernel module > - same enhancements as my earlier QT1010 125kHz patch > - tuner initialization > - register 1f calculation > - register 20 calculation > - register 25 calculation > > gl861: (MSI Megasky) > - hack for enable ZL10353 / QT1010 I2C gate, fixed later.. > - use new QT1010 module instead of old code > > au6610: (Sigmatek DVB-110) > - hack for enable ZL10353 / QT1010 I2C gate, fixed later.. > - use new QT1010 module instead of old code > > m920x: (MSI Megasky) > - use new QT1010 module instead of old code > > Tested successfully with au6610 and gl861 devices against fi-Yllas > frequencies. Now it locks perfectly with both devices. > > There is a "hack" to enable probable i2c gate in zl10535 demodulator. > QT1010 doesn't respond to any i2c messages before we write 0x1a to > demodulator register 0x62. In my understanding this should be fixed > to demodulator code. It could be also possible that new qt1010 module > does not get detected in m9206 based Megasky due to different > demodulator and different gate. I couldn't test this due to lack of > m9206 based Megasky. > > Aapo, could you especially check and test m9206 based Megasky? Doesn't work anymore. "status 00 | signal 000f | snr 0000 | ber 00000000 | unc 00000000 | " in short. -- Aapo Tahkola _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
