Hartmut Hackmann wrote: > Hi > > ranger719@xxxxxx wrote: >> Hi, >> I own this card and I am unable to get it working under linux. I have >> posted much info here: >> http://forums.gentoo.org/viewtopic-p-3659011.html#3659011(I hope it is >> okay not to post everything here again). >> There you can look at dmesg, lspci etc output and what does/does not >> work. If you need more just ask. You can answer in the forum or here. >> I searched the old topics here about this card but nothing seems to >> work. :( I guess it has something to do with the firmware. >> >> Greetings and Thanks, >> Johannes >> > The point is this message: > > Oct 20 02:01:33 shodan tuner 1-004b: type set to tda8290+75a > > Your card is equipped with a tda8275a tuner while the driver expects > a non a version. These are not software compatible. > > If your card has 2 tuners, you might be more lucky if you force the > card type to 88. So > modprobe saa7134 card=88 > modprobe saa7134-alsa > modprobe saa7134-dvb > > Good luck > Hartmut > Hello, sorry for the delay. I have tested it with card=88. The card is not working yet. Here are the results: Oct 23 10:26:02 shodan Linux video capture interface: v2.00 Oct 23 10:26:02 shodan saa7130/34: v4l2 driver version 0.2.14 loaded Oct 23 10:26:02 shodan saa7134 ALSA driver for DMA sound loaded Oct 23 10:26:02 shodan saa7134 ALSA: no saa7134 cards found <- card not yet inserted.. Oct 23 10:26:04 shodan pccard: CardBus card inserted into slot 0 Oct 23 10:26:04 shodan PCI: Enabling device 0000:05:00.0 (0000 -> 0002) Oct 23 10:26:04 shodan ACPI: PCI Interrupt 0000:05:00.0[A] -> GSI 16 (level, low) -> IRQ 17 Oct 23 10:26:04 shodan saa7133[0]: found at 0000:05:00.0, rev: 208, irq: 17, latency: 0, mmio: 0xa2000000 Oct 23 10:26:04 shodan PCI: Setting latency timer of device 0000:05:00.0 to 64 Oct 23 10:26:04 shodan saa7133[0]: subsystem: 4e42:0502, board: Tevion/KWorld DVB-T 220RF [card=88,insmod option] Oct 23 10:26:04 shodan saa7133[0]: board init: gpio is 8210000 Oct 23 10:26:04 shodan saa7133[0]: i2c eeprom 00: 42 4e 02 05 54 20 1c 00 43 43 a9 1c 55 d2 b2 92 Oct 23 10:26:04 shodan saa7133[0]: i2c eeprom 10: 00 ff 22 0f ff 20 ff ff ff ff ff ff ff ff ff ff Oct 23 10:26:04 shodan saa7133[0]: i2c eeprom 20: 01 40 01 03 03 01 01 03 08 ff 01 81 ff ff ff ff Oct 23 10:26:04 shodan saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff Oct 23 10:26:04 shodan saa7133[0]: i2c eeprom 40: ff 25 00 c0 ff 10 07 01 c2 96 00 16 22 15 ff ff Oct 23 10:26:04 shodan saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff Oct 23 10:26:04 shodan saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff Oct 23 10:26:04 shodan saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff Oct 23 10:26:04 shodan saa7133[0]: i2c scan: found device @ 0x10 [???] Oct 23 10:26:04 shodan saa7133[0]: i2c scan: found device @ 0x96 [???] Oct 23 10:26:04 shodan saa7133[0]: i2c scan: found device @ 0xa0 [eeprom] Oct 23 10:26:04 shodan tuner 1-004b: chip found @ 0x96 (saa7133[0]) Oct 23 10:26:04 shodan tuner 1-004b: setting tuner address to 61 Oct 23 10:26:04 shodan tuner 1-004b: type set to tda8290+75a Oct 23 10:26:04 shodan saa7133[0]: registered device video0 [v4l2] Oct 23 10:26:04 shodan saa7133[0]: registered device vbi0 Oct 23 10:26:04 shodan saa7133[0]: registered device radio0 Oct 23 10:26:04 shodan DVB: registering new adapter (saa7133[0]). Oct 23 10:26:04 shodan DVB: registering frontend 0 (Philips TDA10046H DVB-T)... Oct 23 10:26:04 shodan saa7133[0]/alsa: saa7133[0] at 0xa2000000 irq 17 registered as card -1 after 'dvbscan /usr/share/dvb/scan/dvb-t/de-Ruhrgebiet' (used perl get_dvb_firmware tda10046 and the orange light is NOT working, only the green one on the device. I think the orange one indicates that a firmware is loaded?) Oct 23 10:27:11 shodan tda1004x: setting up plls for 48MHz sampling clock Oct 23 10:27:13 shodan tda1004x: timeout waiting for DSP ready Oct 23 10:27:13 shodan tda1004x: found firmware revision 0 -- invalid Oct 23 10:27:13 shodan tda1004x: booting from eeprom Oct 23 10:27:15 shodan tda1004x: timeout waiting for DSP ready Oct 23 10:27:15 shodan tda1004x: found firmware revision 0 -- invalid Oct 23 10:27:15 shodan tda1004x: firmware upload failed and the output of dvbscan: scanning /usr/share/dvb/scan/dvb-t/de-Ruhrgebiet using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0' initial transponder 538000000 0 2 9 1 1 3 0 initial transponder 586000000 0 2 9 1 1 3 0 initial transponder 722000000 0 2 9 1 1 3 0 initial transponder 746000000 0 2 9 1 1 3 0 initial transponder 818000000 0 2 9 1 1 3 0 initial transponder 690000000 0 2 9 1 1 3 0 initial transponder 506000000 0 2 9 1 1 2 0 initial transponder 674000000 0 2 9 1 1 3 0 initial transponder 778000000 0 2 9 1 1 2 0 >>> tune to: 538000000:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_2_3:FEC_AUTO:QAM_16:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_4:HIERARCHY_NONE WARNING: filter timeout pid 0x0011 WARNING: filter timeout pid 0x0000 WARNING: filter timeout pid 0x0010 >>> tune to: 586000000:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_2_3:FEC_AUTO:QAM_16:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_4:HIERARCHY_NONE WARNING: filter timeout pid 0x0011 WARNING: filter timeout pid 0x0000 WARNING: filter timeout pid 0x0010 >>> tune to: 722000000:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_2_3:FEC_AUTO:QAM_16:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_4:HIERARCHY_NONE WARNING: filter timeout pid 0x0011 WARNING: filter timeout pid 0x0000 WARNING: filter timeout pid 0x0010 >>> tune to: 746000000:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_2_3:FEC_AUTO:QAM_16:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_4:HIERARCHY_NONE WARNING: filter timeout pid 0x0011 WARNING: filter timeout pid 0x0000 WARNING: filter timeout pid 0x0010 >>> tune to: 818000000:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_2_3:FEC_AUTO:QAM_16:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_4:HIERARCHY_NONE ...and so on... dumping lists (0 services) Done. Greetings, Johannes _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
