> tis 2006-09-26 klockan 09:57 +0200 skrev Jimmy Hedman: >> On Mon, 2006-09-25 at 23:40 +0200, Hartmut Hackmann wrote: >> > Hi, >> > >> > Jimmy Hedman wrote: >> > > Hi, >> > > I have a Compro DVB-T 300 which uses the saa7134-dvb-driver. When >> it's >> > > tuned it is flooding my system with between 12000 and 16000 >> interrupts a >> > > second. It works, but that amout of interrupts doesn't sound healty. >> Any >> > > ideas what this could be? >> > > >> > > Many thanks in advance, >> > > Jimmy Hedman >> > > >> > The streaming DMA causes loads of interrupts, but not that many. >> > For DVB-T you should expect about 70 per sec, and for analog, its >> > up to 50 per sec for 50Hz systems. >> > The only other valid interrupt source are the GPIOs (Remote control). >> > If there really are so many interrupts, there must be something wrong >> > with the GPIO config but i don't think so. >> I actually have a problem with the remote! It's giving the last pressed >> key plus the current key every time which makes it impossible to use. >> The first key goes through, but all the following keys gets duplicated >> on the next key press. For example, if I press DOWN, DOWN, UP, LEFT, i >> get DOWN, DOWN+DOWN, DOWN+UP, UP+LEFT. >> Can I debug this in any way? > I did some debugging with 'ir_debug=1 i2c_debug=1 irq_debug=1 > gpio_tracking=1' for saa7134 and 'debug=1' on both ir_common and > ir_kbd_i2c and when i do this the remote seem to be working fine. > I have logfiles at http://www.linuxguru.se/temp/messages.gz and > http://www.linuxguru.se/temp/syslog.gz if anyone is interrested in > looking at it. The flooding of interrupts continued when I added the debug-options to the modules so this is still an "issue". // Jimmy _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
