Tuning fails with 2.6.18 kernel, firmware gets loaded. Box is Artec T1 USB1.1 TVBOX with AN2235 (faulty USB IDs) works fine with 2.6.17.13 Tuning with tzap gives: [...] tuning to 578000000 Hz video pid 0x0161, audio pid 0x0162 status 00 | signal 0000 | snr 0000 | ber 001fffff | unc 0000ffff | status 04 | signal 0000 | snr 0000 | ber 001fffff | unc 0000ffff | status 04 | signal 0000 | snr 0000 | ber 001fffff | unc 0000ffff | status 04 | signal 0000 | snr 0000 | ber 001fffff | unc 0000ffff | status 04 | signal 0000 | snr 0000 | ber 001fffff | unc 0000ffff | status 04 | signal 0000 | snr 0000 | ber 001fffff | unc 0000ffff | [...] dmesg output: usb 1-1.3: new full speed USB device using ehci_hcd and address 13 usb 1-1.3: configuration #1 chosen from 1 choice dvb-usb: found a 'Artec T1 USB1.1 TVBOX with AN2235 (faulty USB IDs)' in cold state, will try to load a firmware dvb-usb: downloading firmware from file 'dvb-usb-dibusb-an2235-01.fw' usbcore: registered new driver dvb_usb_dibusb_mb usb 1-1.1: USB disconnect, address 12 dvb-usb: generic DVB-USB module successfully deinitialized and disconnected. usb 1-1.1: new full speed USB device using ehci_hcd and address 14 usb 1-1.1: configuration #1 chosen from 1 choice dvb-usb: found a 'DiBcom USB1.1 DVB-T reference design (MOD3000)' in warm state. dvb-usb: will use the device's hardware PID filter (table count: 16). DVB: registering new adapter (DiBcom USB1.1 DVB-T reference design (MOD3000)). DVB: registering frontend 0 (DiBcom 3000M-B DVB-T)... dibusb: This device has the Thomson Cable onboard. Which is default. input: IR-receiver inside an USB DVB receiver as /class/input/input7 dvb-usb: schedule remote query interval to 150 msecs. dvb-usb: DiBcom USB1.1 DVB-T reference design (MOD3000) successfully initialized and connected. _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
