Dominik Kuhlen wrote: > Hi, > On Friday 22 September 2006 13:15, Roland Mieslinger wrote: >> Hi Dominik, >> >> looks like we're doing the same. I've started a driver for pctv452 too, but >> belive that I'm a bit behind (I can only init the device on usb connect). > I use the init values from stb0899 driver, I think there should be no > critical (breaking the device if set incorrect) values. > Maybe some timing stuff is set differently. Timing is all calculated in the tuning algorithm. so shouldn't matter much, rest DVB-S2 specific things are all very much clock speed dependent. >> Should we try to share afford? > Sure, if you like I can send you (or to the list if others are also > interested) my code and diffs I have done so far: Would be nice > -Setting LNB voltage and sending DiSEqC should work. This depends upon the board configuration, different boards are using different setup 's. > -Tuning does not work yet, stb6100 functions do not get called. I currently use a TDA8261 PLL based tuner not the STB6100 and hence. Some more refinements going on. > -Hot-unplug is not supported (oopsing kernel). Hmm .. the driver is not yet released .. very much in pre-alpha state where some people are contributing as well. Quite a few more things to be done. Manu _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb