Hi, Frederico
Federico Cozzi wrote:
Hi,
I've a lifeview flydvb-t duo but i'm unable to get it working under
fedora core 5 (opensue 10.1: the same), the card was sold in bundle with
a Targa laptop in Lidl shops...
Here is the dmesg log:
02:00.0 Multimedia controller: Philips Semiconductors SAA7133/SAA7135
Video Broadcast Decoder (rev f0)
Linux video capture interface: v1.00
saa7130/34: v4l2 driver version 0.2.14 loaded
PCI: Enabling device 0000:02:00.0 (0000 -> 0002)
ACPI: PCI Interrupt 0000:02:00.0[A] -> GSI 18 (level, low) -> IRQ 169
saa7133[0]: found at 0000:02:00.0, rev: 240, irq: 169, latency: 0, mmio:
0x42000000
PCI: Setting latency timer of device 0000:02:00.0 to 64
saa7133[0]: subsystem: 5168:0502, board: LifeView/Typhoon FlyDVB-T Duo
Cardbus [card=60,autodetected]
saa7133[0]: board init: gpio is 210000
saa7133[0]: i2c eeprom 00: 68 51 02 05 54 20 1c 00 43 43 a9 1c 55 d2 b2 92
saa7133[0]: i2c eeprom 10: 00 00 62 08 ff 20 ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 20: 01 40 01 03 03 01 01 03 08 ff 01 e4 ff ff ff ff
saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 40: ff 24 00 c2 96 10 05 01 01 16 32 15 ff ff ff ff
saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
tuner 1-004b: chip found @ 0x96 (saa7133[0])
tuner 1-004b: setting tuner address to 61
tuner 1-004b: tuner: type set to tda8290+75
saa7133[0]: registered device video0 [v4l2]
saa7133[0]: registered device vbi0
saa7133[0]: registered device radio0
When i start to scan the stations with kaffeine (after i've loaded the
module with: modprobe saa7134-dvb), i get this error message:
DVB: registering new adapter (saa7133[0]).
DVB: registering frontend 0 (Philips TDA10046H DVB-T)...
tda1004x: setting up plls for 48MHz sampling clock
tda1004x: found firmware revision ff -- invalid
tda1004x: booting from eeprom
tda1004x: found firmware revision ff -- invalid
tda1004x: firmware upload failed
Should i've to upgrade the firmware? Where can i find a new one?
Or the problem is somewehere else?
Many thanks in advance
Federico Cozzi
The problem is - as you already found - that the channel decoder
could not load its firmware. Somebody else already reported this
but we could not identify the problem precisely. As far as i remember,
it vanished after a firmware update...
Do you have windows installed? If yes, please get a driver update
from lifeview and let the card run once in windows.
There is a basic firmware writer. I stated reworking it to make it
safer but ths is not finished yet. If you can't update / rewrite the
firmware through windows, please leave me a note, i will send you a
snapshot and a recent firmware image.
Hartmut
_______________________________________________
linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
