Hi Mark & Hartmut, >Hi, Mark > >Mark Callaghan wrote: >> I have done a mythdora install, with some problems with the remote on >> the Compro DVB-T300. The card is not registering as an input device, as >> it did with a previous install (earlier kernel, dvb module build from >> cvs). Relevant parts of dmesg (from a cold boot) below. Two items of >> interest: >> >> input: device saa7134 IR (Compro Videomate DV is statically >> allocated, will not register >> Please convert to input_allocate_device() or contact >> saa7134[0]: registered input device for IR >> and >> >> tuner 2-0061: i2c i/o error: rc == -5 (should be 4) >> I don't know if this "tuner 2..." line means anything or not. >> >> Has there been some change in the kernel that saa7134 doesn't know >> about? Is there a possible build problem with mythdora? >> >I can't tell about the remote control since i don't have such a card, >only a similar one without remote. >The message concerning the tuner can occur if a tv application tries >to access the tuner while the card is in DVB-T mode. This can not work, >there is only one tuner for both modes. > >Best regards > Hartmut I have seen a very similar dmesg error message that Mark has seen: tuner 2-0061: i2c i/o error: rc == -5 (should be 4) but only ever with the second of my two cards. It does not happen consistently and has not happened in my most recent boot, so I can't confirm that it is identical. I am confident about the "i2c i/o error: rc == -5 (should be 4)" bit but not about the "tuner 2-0061:" bit. Mark, have you ever seen a problem with your remote control like the I described in this post: http://www.linuxtv.org/pipermail/linux-dvb/2006-March/008705.html Regards, James. |
_______________________________________________ linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
