Thanks for the response Mike. I've tried those steps and still no joy.
I can't see anything in the logs (/var/log/messages or dmesg) about the
second tuner or the firmware. From others posts, I think I should see
something about the driver going looking for the fw. Is this correct ? Is
there a specific module which needs to be loaded ?
I'm running 2.6.15
Thanks again, Regards
Lachlan
lsmod
Module Size Used by
dvb_usb_cxusb 16516 0
dvb_usb 19848 1 dvb_usb_cxusb
parport_pc 28612 1
lp 13512 0
parport 37064 2 parport_pc,lp
autofs4 20996 0
eeprom 7568 0
it87 21284 0
hwmon_vid 2944 1 it87
i2c_isa 5504 1 it87
sunrpc 153916 1
xfs 579016 1
exportfs 6784 1 xfs
dm_mod 60824 0
video 16004 0
button 6928 0
battery 9732 0
ac 5124 0
nvidia 4090832 12
ipv6 262880 20
ohci1394 35380 0
ieee1394 303448 1 ohci1394
ohci_hcd 22148 0
ehci_hcd 35336 0
cx88_blackbird 20508 0
cx8800 33676 1 cx88_blackbird
compat_ioctl32 1280 1 cx8800
v4l1_compat 12932 1 cx8800
v4l2_common 15744 2 cx88_blackbird,cx8800
i2c_nforce2 7168 0
cx88_dvb 12292 0
cx8802 12292 2 cx88_blackbird,cx88_dvb
cx88xx 61860 4 cx88_blackbird,cx8800,cx88_dvb,cx8802
ir_common 27140 1 cx88xx
btcx_risc 5000 3 cx8800,cx8802,cx88xx
tveeprom 14992 1 cx88xx
videodev 10112 3 cx88_blackbird,cx8800,cx88xx
cx88_vp3054_i2c 4352 1 cx88_dvb
i2c_algo_bit 9352 2 cx88xx,cx88_vp3054_i2c
mt352 6660 2 dvb_usb_cxusb,cx88_dvb
or51132 9860 1 cx88_dvb
video_buf_dvb 6788 1 cx88_dvb
dvb_core 84008 2 dvb_usb,video_buf_dvb
video_buf 22276 6
cx88_blackbird,cx8800,cx88_dvb,cx8802,cx88xx,video_buf_dvb
nxt200x 14468 1 cx88_dvb
cx24123 9220 1 cx88_dvb
lgdt330x 7964 2 dvb_usb_cxusb,cx88_dvb
cx22702 6660 2 dvb_usb_cxusb,cx88_dvb
i2c_core 22144 15
dvb_usb,eeprom,it87,i2c_isa,i2c_nforce2,cx88_dvb,cx88xx,tveeprom,i2c_algo_bit,mt352,or51132,nxt200x,cx24123,lgdt330x,cx22702
dvb_pll 11908 6
dvb_usb_cxusb,dvb_usb,cx88_dvb,or51132,nxt200x,cx22702
snd_intel8x0 32924 0
snd_ac97_codec 91040 1 snd_intel8x0
snd_ac97_bus 2688 1 snd_ac97_codec
snd_pcm_oss 53664 0
snd_mixer_oss 19072 1 snd_pcm_oss
snd_pcm 93444 3 snd_intel8x0,snd_ac97_codec,snd_pcm_oss
snd_timer 26500 1 snd_pcm
snd 58084 6
snd_intel8x0,snd_ac97_codec,snd_pcm_oss,snd_mixer_oss,snd_pcm,snd_timer
soundcore 10336 1 snd
snd_page_alloc 11272 2 snd_intel8x0,snd_pcm
forcedeth 24580 0
floppy 63556 0
ext3 135688 2
jbd 61204 1 ext3
Feb 20 18:26:22 localhost kernel: Linux video capture interface: v1.00
Feb 20 18:26:22 localhost kernel: cx2388x dvb driver version 0.0.5 loaded
Feb 20 18:26:22 localhost kernel: CORE cx88[0]: subsystem: 18ac:db50,
board: DViCO FusionHDTV DVB-T Dual Digita
l [card=44,autodetected]
Feb 20 18:26:22 localhost kernel: TV tuner 4 at 0x1fe, Radio tuner -1 at
0x1fe
Feb 20 18:26:22 localhost kernel: ACPI: PCI Interrupt Link [LNK3] enabled
at IRQ 12
Feb 20 18:26:22 localhost kernel: PCI: setting IRQ 12 as level-triggered
Feb 20 18:26:22 localhost kernel: ACPI: PCI Interrupt 0000:01:06.2[A] ->
Link [LNK3] -> GSI 12 (level, low) ->
IRQ 12
Feb 20 18:26:22 localhost kernel: cx88[0]/2: found at 0000:01:06.2, rev:
5, irq: 12, latency: 32, mmio: 0xdf000
000
Feb 20 18:26:22 localhost kernel: cx88[0]/2: cx2388x based dvb card
Feb 20 18:26:22 localhost kernel: DVB: registering new adapter (cx88[0]).
Feb 20 18:26:22 localhost kernel: DVB: registering frontend 0 (Zarlink
MT352 DVB-T)...
Feb 20 18:26:22 localhost kernel: i2c_adapter i2c-1: nForce2 SMBus adapter
at 0x5000
Feb 20 18:26:22 localhost kernel: i2c_adapter i2c-2: nForce2 SMBus adapter
at 0x5100
Feb 20 18:26:22 localhost kernel: cx2388x v4l2 driver version 0.0.5 loaded
Feb 20 18:26:22 localhost kernel: ACPI: PCI Interrupt 0000:01:06.0[A] ->
Link [LNK3] -> GSI 12 (level, low) ->
IRQ 12
Feb 20 18:26:22 localhost kernel: cx88[0]/0: found at 0000:01:06.0, rev:
5, irq: 12, latency: 32, mmio: 0xde000
000
Feb 20 18:26:22 localhost kernel: cx88[0]/0: registered device video0
[v4l2]
Feb 20 18:26:22 localhost kernel: cx88[0]/0: registered device vbi0
Feb 20 18:26:22 localhost kernel: set_control id=0x980900 reg=0x310110
val=0x00 (mask 0xff)
Feb 20 18:26:22 localhost kernel: set_control id=0x980901 reg=0x310110
val=0x3f00 (mask 0xff00)
Feb 20 18:26:22 localhost kernel: set_control id=0x980903 reg=0x310118
val=0x00 (mask 0xff)
Feb 20 18:26:22 localhost xinetd[3697]: xinetd Version 2.3.13 started with
libwrap loadavg options compiled in.
Feb 20 18:26:22 localhost kernel: set_control id=0x980902 reg=0x310114
val=0x5a7f (mask 0xffff)
lspci
00:00.0 Host bridge: nVidia Corporation nForce2 AGP (different version?)
(rev a2)
00:00.1 RAM memory: nVidia Corporation nForce2 Memory Controller 1 (rev
a2)
00:00.2 RAM memory: nVidia Corporation nForce2 Memory Controller 4 (rev
a2)
00:00.3 RAM memory: nVidia Corporation nForce2 Memory Controller 3 (rev
a2)
00:00.4 RAM memory: nVidia Corporation nForce2 Memory Controller 2 (rev
a2)
00:00.5 RAM memory: nVidia Corporation nForce2 Memory Controller 5 (rev
a2)
00:01.0 ISA bridge: nVidia Corporation nForce2 ISA Bridge (rev a3)
00:01.1 SMBus: nVidia Corporation nForce2 SMBus (MCP) (rev a2)
00:02.0 USB Controller: nVidia Corporation nForce2 USB Controller (rev a3)
00:02.1 USB Controller: nVidia Corporation nForce2 USB Controller (rev a3)
00:02.2 USB Controller: nVidia Corporation nForce2 USB Controller (rev a3)
00:04.0 Ethernet controller: nVidia Corporation nForce2 Ethernet
Controller (rev a1)
00:05.0 Multimedia audio controller: nVidia Corporation nForce MultiMedia
audio [Via VT82C686B] (rev a2)
00:06.0 Multimedia audio controller: nVidia Corporation nForce2 AC97 Audio
Controler (MCP) (rev a1)
00:08.0 PCI bridge: nVidia Corporation nForce2 External PCI Bridge (rev
a3)
00:09.0 IDE interface: nVidia Corporation nForce2 IDE (rev a2)
00:0d.0 FireWire (IEEE 1394): nVidia Corporation nForce2 FireWire (IEEE
1394) Controller (rev a3)
00:1e.0 PCI bridge: nVidia Corporation nForce2 AGP (rev a2)
01:06.0 Multimedia video controller: Conexant Winfast TV2000 XP (rev 05)
01:06.2 Multimedia controller: Conexant: Unknown device 8802 (rev 05)
02:00.0 VGA compatible controller: nVidia Corporation NV18 [GeForce4 MX -
nForce GPU] (rev a3)
[root@localhost ~]#
On 2/18/06, lkidd@xxxxxxxxxxxxxx <lkidd@xxxxxxxxxxxxxx> wrote:
>> Hello,
>> I've been reading on this list that a few people have had some success
>> in getting both tuners
going. Is there any chance on posting a how-to on what was required ? I've
got the first tuner going no probs and love it. The second tuner is
causing some greif. From what I've read, I've downloaded the firmware, and
loaded dvb_usb_cxusb and dvb_usb . Somewhat of a concern is the both
dmesg and var/log/messages are very quite about the whole thing. The
modules load but nothing else is repored. Also, what /dev entry does the
usb tuner show up under ?
>> Thanks, Regards
>> Lachlan
1) install mercurial
2) hg clone http://linuxtv.org/hg/v4l-dvb
3) cd v4l-dvb
4) linux/Documentation/dvb/get_dvb_firmware bluebird
5) mv dvb-usb-bluebird-01.fw /usr/lib/hotplug/firmware/
6) make
7) make install
8) reboot
I hope this helps,
Mike
_______________________________________________
linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
