Hi, I have a Twinhan VisionPlus VP-TER-3040-B and using 2.6.15-r1 kernel. My problem is that I can only tune in channels when the CI is disconnected. Some hints what I could do to make it work? Here is what ca_zap tells me (after tzap has found the channel) and dmesg: $ ca_zap -c channels.conf -t ter -n ZTV Using Adpater=[/dev/dvb/adapter0] Frontend=[/dev/dvb/adapter0/frontend0] Demux=[/dev/dvb/adapter0/demux0] Slot=[/dev/dvb/adapter0/ca0] Parsing channels.conf Terrestrial frontend ERROR: transmission_mode field syntax error Service ID=[0] parse_pat: ----------------->parse PAT section parse_pat: PAT => Section Length=[53], TS ID=[1111] parse_si: PMT PID = [16] parse_si: PAT: Close Demux /dev/dvb/adapter0/demux0 Or ... $ ca_zap -c channels.conf -n ZTV Using Adpater=[/dev/dvb/adapter0] Frontend=[/dev/dvb/adapter0/frontend0] Demux=[/dev/dvb/adapter0/demux0] Slot=[/dev/dvb/adapter0/ca0] Parsing channels.conf parse_pat: ----------------->parse PAT section parse_pat: PAT => Section Length=[53], TS ID=[1111] parse_si: PMT PID = [16] parse_si: PAT: Close Demux /dev/dvb/adapter0/demux0 And this is what I got from dmesg ... i2c /dev entries driver Linux video capture interface: v1.00 bttv: driver version 0.9.16 loaded bttv: using 8 buffers with 2080k (520 pages) each for capture bttv: Bt8xx card found (0). ACPI: PCI Interrupt 0000:00:09.0[A] -> Link [LNKD] -> GSI 9 (level, low) -> IRQ 9 bttv0: Bt878 (rev 17) at 0000:00:09.0, irq: 9, latency: 32, mmio: 0xe7000000 bttv0: detected: Twinhan VisionPlus DVB [card=113], PCI subsystem ID is 1822:0001 bttv0: using: Twinhan DST + clones [card=113,autodetected] bttv0: gpio: en=00000000, out=00000000 in=00f500fd [init] bttv0: using tuner=4 bttv0: add subdevice "dvb0" bt878: AUDIO driver version 0.0.0 loaded bt878: Bt878 AUDIO function found (0). ACPI: PCI Interrupt 0000:00:09.1[A] -> Link [LNKD] -> GSI 9 (level, low) -> IRQ 9 bt878(0): Bt878 (rev 17) at 00:09.1, irq: 9, latency: 32, memory: 0xe6800000 DVB: registering new adapter (bttv0). dst_get_device_id: Recognise [DTT-CI] DST type flags : 0x1 newtuner 0x2 ts204 0x10 firmware version = 2 dst_get_mac: MAC Address=[00:08:ca:17:cd:00] dst_ca_attach: registering DST-CA device DVB: registering frontend 0 (DST DVB-T)... ... regards, Tomas _______________________________________________ linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
