Hello
I have two asus hybrid cards. The analog works well, but the DVB-T side
has something wrong.
When I try scan:
[root@hondchan scan]# ./scan dvb-t/fi-Espoo
scanning dvb-t/fi-Espoo
using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0'
initial transponder 562000000 0 2 0 3 1 2 0
>>> tune to:
562000000:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_2_3:FEC_NONE:QAM_64:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_8:HIERARCHY_NONE
WARNING: >>> tuning failed!!!
>>> tune to:
562000000:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_2_3:FEC_NONE:QAM_64:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_8:HIERARCHY_NONE
(tuning failed)
WARNING: >>> tuning failed!!!
ERROR: initial tuning failed
dumping lists (0 services)
Done.
Any ideas how this issue could be solved?
Here are the init messages for one card:
ACPI: PCI Interrupt 0000:01:0a.0[A] -> Link [LNK1] -> GSI 5 (level, low)
-> IRQ 5
saa7133[1]: found at 0000:01:0a.0, rev: 208, irq: 5, latency: 32, mmio:
0xe8006000
saa7133[1]: subsystem: 1043:4862, board: ASUSTeK P7131 Dual
[card=78,autodetected]
saa7133[1]: board init: gpio is 40000
saa7133[1]/core: hwinit1
tuner 3-004b: chip found @ 0x96 (saa7133[1])
tuner 3-004b: setting tuner address to 61
tuner 3-004b: tuner: type set to tda8290+75a
saa7133[1]: i2c eeprom 00: 43 10 62 48 54 20 1c 00 43 43 a9 1c 55 d2 b2 92
saa7133[1]: i2c eeprom 10: 00 01 20 00 ff 20 ff ff ff ff ff ff ff ff ff ff
saa7133[1]: i2c eeprom 20: 01 40 01 02 03 01 01 03 08 ff 00 d6 ff ff ff ff
saa7133[1]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[1]: i2c eeprom 40: ff 21 00 c2 96 10 03 32 15 00 ff ff ff ff ff ff
saa7133[1]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[1]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[1]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[1]/core: hwinit2
saa7133[1]: registered device video1 [v4l2]
saa7133[1]: registered device vbi1
saa7133[1]: registered device radio1
DVB: registering new adapter (saa7133[1]).
DVB: registering frontend 1 (Philips TDA10046H DVB-T)...
I am running self compiled kernel version 2.6.15. The chips on the card
are SAA7134, TDA8275 and TDA10046. There is not problem with the signal,
since DVB-T settop box works with no problems. I fetched the firmware
last week and installed it as instructed.
-Mikko
--
Mikko Rönkkö +358 50 387 8155 http://www.iki.fi/mronkko
_______________________________________________
linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
