Il giorno dom, 12/02/2006 alle 12.38 +0100, tim0m1a ha scritto: > you would have some trouble to get the pinnacle running under > kernel-versions newer than 2.6.12 but as you use a 2.6.12-Kernel-Version > you should try this v4l-snapshot: > http://www.linuxtv.org/downloads/video4linux/video4linux-20050627.tar.gz > This works fine for me, but it is the only snapshot working on my machine. I'm afraid I have trouble installing the snapshot. I untar/gz it in a new directory, then type make and finally make install. Everything seems to be ok, but then when I modprobe saa7134-dvb the module doesn't load: Linux video capture interface: v1.00 saa7130/34: v4l2 driver version 0.2.13 loaded saa7130/34: snapshot date 2005-06-27 ACPI: PCI Interrupt 0000:05:07.0[A] -> Link [APC2] -> GSI 17 (level, low) -> IRQ 17 saa7133[0]: found at 0000:05:07.0, rev: 208, irq: 17, latency: 32, mmio: 0xd900a000 saa7133[0]: subsystem: 11bd:002f, board: UNKNOWN/GENERIC [card=0,autodetected] saa7133[0]: board init: gpio is 600e000 saa7133[0]: dsp access wait timeout [bit=WRR] saa7133[0]: dsp access wait timeout [bit=WRR] saa7133[0]: dsp access wait timeout [bit=WRR] saa7133[0]: i2c eeprom read error (err=-5) saa7133[0]: registered device video0 [v4l2] saa7133[0]: registered device vbi0 saa7134_dvb: Unknown symbol videobuf_dvb_unregister saa7134_dvb: Unknown symbol videobuf_dvb_register video_buf_dvb: disagrees about version of symbol dvb_dmxdev_init video_buf_dvb: Unknown symbol dvb_dmxdev_init video_buf_dvb: disagrees about version of symbol dvb_dmx_release video_buf_dvb: Unknown symbol dvb_dmx_release video_buf_dvb: disagrees about version of symbol dvb_net_init video_buf_dvb: Unknown symbol dvb_net_init video_buf_dvb: disagrees about version of symbol dvb_dmx_swfilter video_buf_dvb: Unknown symbol dvb_dmx_swfilter video_buf_dvb: disagrees about version of symbol dvb_dmxdev_release video_buf_dvb: Unknown symbol dvb_dmxdev_release video_buf_dvb: disagrees about version of symbol dvb_net_release video_buf_dvb: Unknown symbol dvb_net_release video_buf_dvb: disagrees about version of symbol dvb_unregister_frontend video_buf_dvb: Unknown symbol dvb_unregister_frontend video_buf_dvb: disagrees about version of symbol dvb_register_frontend video_buf_dvb: Unknown symbol dvb_register_frontend video_buf_dvb: disagrees about version of symbol dvb_dmx_init video_buf_dvb: Unknown symbol dvb_dmx_init saa7134_dvb: Unknown symbol videobuf_dvb_unregister saa7134_dvb: Unknown symbol videobuf_dvb_register I think that there might be some missing modules, as if I manually remove every v4l module in my system and then try to reinstall the snapshot, when I modprobe saa7134-dvb many more missing symboles are found. How should I use that snapshot? > Please keep in mind, that you must flash at least the 1.11-Firmware > version onto your card via Windows, otherwise the card would not work. I'm afraid I have no way to flash the firmware. In fact, I even think that there is no eprom chip to flash on my card. Under Windows I can only flash a 300i card, I do not have any utilities on the Pinnacle install cds to flash the 310i card. Regards, Pierluigi _______________________________________________ linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
