Hi all, Have an iVogue dvb20 usb card thats recognised as a Zarlink MT352 chipset. have installed all components and drivers needed, firmware loads up ok and unit powers up ok. kernel is 2.6.15, running mepis (debian based) setup process fails with the ./scan /dvb-t/uk-CrystalPalace command,giving CODE scanning dvb-t/uk-CrystalPalace using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0' initial transponder 505833333 0 3 0 1 0 0 0 >>> tune to: 505833333:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_3_4:FEC_NONE:QAM_16:TRANSMISSION_MODE_2K:GUARD_INTERVAL_1_32:HIERARCHY_NONE WARNING: >>> tuning failed!!! >>> tune to: 505833333:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_3_4:FEC_NONE:QAM_16:TRANSMISSION_MODE_2K:GUARD_INTERVAL_1_32:HIERARCHY_NONE (tuning failed) WARNING: >>> tuning failed!!! ERROR: initial tuning failed dumping lists (0 services) Done. Crystal palace is about a mile away. device files seem ok.... CODE admin@3[~]$ ls -al /dev/dvb/adapter0/ total 0 drwxr-xr-x 2 root root 120 2006-01-20 02:44 . drwxr-xr-x 3 root root 60 2006-01-20 02:44 .. crw-rw---- 1 root video 212, 4 2006-01-20 02:44 demux0 crw-rw---- 1 root video 212, 5 2006-01-20 02:44 dvr0 crw-rw---- 1 root video 212, 3 2006-01-20 02:44 frontend0 crw-rw---- 1 root video 212, 7 2006-01-20 02:44 net0 i'm in the video group (but get same results as root) relevant bits of lsmod CODE admin@3[~]$ lsmod Module Size Used by dvb_bt8xx 10884 0 nxt6000 6148 1 dvb_bt8xx sp887x 6404 1 dvb_bt8xx dst_ca 10368 1 dvb_bt8xx dst 18820 2 dvb_bt8xx,dst_ca cx24110 6404 1 dvb_bt8xx or51211 8196 1 dvb_bt8xx lgdt330x 6812 1 dvb_bt8xx bt878 7608 2 dvb_bt8xx,dst bttv 143312 2 dvb_bt8xx,bt878 video_buf 15620 1 bttv i2c_algo_bit 7432 1 bttv v4l2_common 4736 1 bttv btcx_risc 3720 1 bttv tveeprom 12432 1 bttv videodev 6912 1 bttv dvb_usb_umt_010 4480 1 mt352 5380 2 dvb_bt8xx,dvb_usb_umt_010 dvb_usb_dibusb_common 5508 1 dvb_usb_umt_010 dib3000mc 12416 1 dvb_usb_dibusb_common dib3000_common 1920 1 dib3000mc dvb_usb 13832 2 dvb_usb_umt_010,dvb_usb_dibusb_common dvb_core 65576 3 dvb_bt8xx,dst_ca,dvb_usb dvb_pll 8836 4 dvb_bt8xx,dvb_usb_umt_010,dvb_usb_dibusb_common,dvb_usb i2c_i801 7052 0 i2c_core 15248 14 dvb_bt8xx,nxt6000,sp887x,dst,cx24110,or51211,lgdt330x,bttv,i2c_algo_bit,tveeprom ,mt352,dib3000_common,dvb_usb,i2c_i801 Tried a scan in kaffeine and that fails too, though once there was a glimmer of progress on the signal to noise progress bar. Antenna is connected. Any ideas? cheers, mat
