Hello Mark, Mark Sutton wrote: >Hi Manu, > Thanks for posting this. I also have the same issues as Mark. >The dst_wait_dst_ready: dst wait NOT ready after 200 > >Although I see a different number of 250 with the v4l-dvb tree on the >newer rev of this card and and this with the older (1022A?): see below > > The reason being i have not moved to v4l-dvb yet and i am on a private repo here. >This mail was started a few days ago, but not finished. >I just haven't had the time to try all the posibilities. > >I have added your patches (there are 5?) to my tree and rebuilt. >I still get the output below, but sometimes I do get a good tune and >have dumped channel lists. I will collect the debug info and post. >Always, if the wait ready is 54 or 53, >the tune fails, good tunes are much faster ~10-12. > > Currently i am on this one and the ATSC fixes. >I have wanted to rebuild all the other tools to be sure they are not >causing problems, but I expect the tuning is still not reliable. >I have not tried with the newer rev of the card. >And unfortunatly the first Pacific storm in a long time has blown up >and moved my dish (held in place by a cinder block) >and now I can't tune anything even with a set top box. > > > Seems bad .. >dst_set_freq: set Frequency 1770000 >dst_set_frontend: Set Frequency=[1770000] >dst_set_symbolrate: set symrate 20000000 >dst_set_symbolrate: set symcalc 238312 >dst_set_polarization: Polarization=[Horizontal] >dst_set_frontend: Set Symbolrate=[20000000] >dst_write_tuna: type_flags 0x16 >dst_comm_init: Initializing DST. >dst_gpio_outb: mask=[ffffffff], enbb=[0001], outhigh=[0000] >rdc_reset_state: Resetting state machine >dst_gpio_outb: mask=[0002], enbb=[0002], outhigh=[0000] >dst_gpio_outb: mask=[0002], enbb=[0002], outhigh=[0002] >writing [ 06 ea 01 3a 2e 80 40 e7 ] >i2c_adapter i2c-0: master_xfer[0] W, addr=0x55, len=8 >bt-i2c: <W aa 06 ea 01 3a 2e 80 40 e7 > >dst_gpio_outb: mask=[ffffffff], enbb=[0000], outhigh=[0000] >i2c_adapter i2c-0: master_xfer[0] R, addr=0x55, len=1 >bt-i2c: <R ab =ff > >read_dst: reply is 0xff >dst_wait_dst_ready: dst wait ready after 54 >i2c_adapter i2c-0: master_xfer[0] R, addr=0x55, len=8 >bt-i2c: <R ab =00 =00 =33 =00 =00 =1e =ff =b0 > >read_dst: reply is 0x0 > >I will repost with a better collection of debug output. >Should I post the output on a website or in the mail? > > > No, this information is quite sufficient for me, thanks for the patience and the right info. Manu
