Forgot to mention I'm using kernel 2.6.14.3 with v4l-dvb cvs from last night. Bryan Scott wrote: > I've scoured the bttv and linux-tv lists for as much info as I could > find about the FujiPlus FD-3250. Linux (bttv) sees it as a Twinhan > VisionPlus clone, but then dst complains it can't find a DST with the > error message(s) included below. > > Other messages suggest it may use a different set of tuners than most > Twinhan's since it's an ATSC/NTSC card with Antenna and Cable F > connectors. > > Any status on patches or specific modules I should be paying attention > to to load this thing? I'm so close I can almost feel it! :) > > -- Bryan > > bt878: AUDIO driver version 0.0.0 loaded > bt878: Bt878 AUDIO function found (0). > bt878(0): Bt878 (rev 17) at 00:0b.1, irq: 18, latency: 32, memory: 0xdddfe000 > DVB: registering new adapter (bttv0). > rdc_8820_reset: Resetting DST > dst_gpio_outb: mask=[0004], enbb=[0004], outhigh=[0000] > dst_gpio_outb: mask=[0004], enbb=[0004], outhigh=[0004] > dst_comm_init: Initializing DST. > dst_gpio_outb: mask=[ffffffff], enbb=[0001], outhigh=[0000] > rdc_reset_state: Resetting state machine > dst_gpio_outb: mask=[0002], enbb=[0002], outhigh=[0000] > dst_gpio_outb: mask=[0002], enbb=[0002], outhigh=[0002] > writing [ 00 06 00 00 00 00 00 fa ] > write_dst: _write_dst error (err == -5, len == 0x08, b0 == 0x00) > dst_error_recovery: Trying to return from previous errors. > dst_gpio_outb: mask=[ffffffff], enbb=[0000], outhigh=[0000] > dst_gpio_outb: mask=[ffffffff], enbb=[0001], outhigh=[0000] > write_dst: _write_dst error (err == -5, len == 0x08, b0 == 0x00) > dst_error_recovery: Trying to return from previous errors. > dst_gpio_outb: mask=[ffffffff], enbb=[0000], outhigh=[0000] > dst_gpio_outb: mask=[ffffffff], enbb=[0001], outhigh=[0000] > write_dst: RDC 8820 RESET > dst_error_bailout: Trying to bailout from previous error. > rdc_8820_reset: Resetting DST > dst_gpio_outb: mask=[0004], enbb=[0004], outhigh=[0000] > dst_gpio_outb: mask=[0004], enbb=[0004], outhigh=[0004] > dst_gpio_outb: mask=[ffffffff], enbb=[0000], outhigh=[0000] > dst_probe: unknown device. > frontend_init: Could not find a Twinhan DST. > dvb-bt8xx: A frontend driver was not found for device 109e/0878 > subsystem 1822/0 001 >
